User's Manual

Busy Channel Lockout

BCLO is to disable transmitting while RX signal is received. Once the channel is busy

and you press PTT, the radio will beep as warning and get back to receiving.

1. In standby,press ,then press to enter into Busy Channel Lockout.

2. Press [ / ] to select the desired value.

BU: Enable BCLO, Carrier lockout, transmitting is inhibited when current channel receives

a matching carrier;press [PTT] to emit error voice prompt.

RL: Enable BTLO, transmitting is inhibited when current channel

receives a matching carrier but dis-matching CTCSS/DCS.press [PTT] to emit error voice

prompt It can transmit in any receiving status.

OFF: Busy channel lockout is disabled.

3. Press number keys to confirm and exit.

NOTE: This function can be temporarily used in Channel mode . Once the radio is turned

off or switched to another channel, the temporary setting will be erased and back to initial

settings.

Reverse TX/RX

TX frequency turns to RX frequency & RX frequency changes

to TX frequency. The signaling will also be reversed if CTCSS/DCS

signaling exited in this channel.

1. In standby,press ,then press ,LCD displays "REV--OF".

2. Press [ / ] to select the desired value.

DOWN

When first bit of Exa byte in frequency displays "D",it indicates

DTMF function enable.

When first bit of Exa byte in frequency displays "T",it indicates

2Tone function enable.

When first bit of Exa byte in frequency displays " ",it indicates

5Tone function enable.

This function can be temporarily used in channel mode. Once the radio is turned off or

switched to another channel, the temporary setting will be erased and back to initial settings.

Scan Skip

In Channel mode,press then press ,decimal point displayed between frequency's

ten digit and unit digit,it means current channel is scan skip. Repeat above operation to set

scan or scan skip in currentchannel.

1. decimal point displayed between frequency's ten digit and unit digit,it means current

channel is scanned skip.

2. decimal point is not displayed between frequency's ten digit and unit digit,it means current

channel is scanned.

Frequency/Channel scan

In corresponding mode,press then press key to enter into scanning.

In scanning mode,press / to change scan direction.

DOWN