User's Manual

ON:Enable Frequency Reverse

OFF:Disable Frequency Reverse

3. Press number keys to confirm and exit.

NOTE: This function can be temporarily used in Channel mode . Once the radio is turned

off or switched to another channel, the temporary setting will be erased and back to initial

settings.

TOT (Time-out timer)

The time-out timer limits the amount of transmitting time. When you reach the time limit

which has been programmed by your dealer, your transmission will be cut off. In order to

transmit again, you must release PTT button to reset the timer.

1. In standby,press ,then press ìLCD displays "TOT-X".

2. Press [ / ] to select the desired value.

3. Press number keys to confirm and exit.

CTCSS/DCS Encode and Decode

1. In standby,press ,then press to enter into CTCSS/DCS Encode and Decode.

2. Repeat above operation to set as below:

LCD displays T icon,it indicates CTCSS encode set in current channel.

LCD displays T and SQ icon,it indicates CTCSS encode and decode set in current channel.

LCD displays DCS icon,it indicates DCS encode and decode set in current channel.

3. In corresponding icon,press [ / ] to select the desired CTCSS/DCS encode

and decode.

DOWN

4. Press * or to confirm and exit.

NOTE:This function can be temporarily used in Channel mode. Once the radio is turned off

or switched to another channel, the temporary setting will be erased and back to initial

settings.

Talk Around

By Talk Around function,you can directly communicate with other radios in your group

in case the repeater is not activated or when you are out of the repeater range. The transceiver

will transmit by RX frequency with its CTCSS/DCS signaling.

1. In standby,press ,then press key,LCD displays "TALK--OF".

2. Press [ / ] to select the desired setting .

ON:Enable Talk Around

OFF:Disable Talk Around

3. Press number keys to confirm and exit.

NOTE: This function can be temporarily used in Channel mode . Once the radio is turned

off or switched to another channel, the temporary setting will be erased and back to initial

settings.

Voice Prompt

The prompting tone provides confirmation of entry, error status or malfunctions of the

transceiver. You can enable or disable this function.

1. In standby,press ,then press ,LCD displays "BEEP--XX".

2. Press [ / ] to turn on/off BEEP voice prompt.

DOWN