User's Manual

NOTE: N is positive code, is negative code, total: 232groups.
66
750
760
770
751
761
771
752
762
772
754
764
774
753
763
773
755
765
775
756
766
776
757
767
777
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful inter-
ference to radio or television reception, which can be determind by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the follwing
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help changes or modifications not
expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
FCC Warning
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This EUT is compliance with SAR for controlled exposure limits in IC RSS -102 and had been
tested in accordance with the measurement methods and procedures specified in IEEE
1528 and IEC 62209. This equipment should be installed and operated with a minimum
distance of 2.5cm must be maintained when held-to-face, and body-worn operations are
restricted to the approve doriginal acessories.
Cet EUT est conforme aux normes SAR pour les limites d’exposition contrôlée de la norme
IC RSS-102 et a été testé conformément aux méthodes et procédures de mesure
spécifiées dans les normes IEEE 1528 et IEC 62209. Cet équipement doit être installé
et utilisé à une distance minimale de 2,5 cm. être maintenu face à face, et les
opérations portées sur le corps sont limitées aux accessoires d'origine approuvés.
IC Warning
67
This device complies with part 15 of the FCC Rules. Operation is subject to the condition that
this device does not cause harmful interference.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment shall be installed and operated with minimum distance 20cm
between the radiator & body.
RF Exposure Warning Statements: