User's Manual

08
Fixed Station Operation
DC power cable with fuse holder
Regulated power supply
Black
Red
Regulated
power supply
1
2
Ineed a separate 13.8V DC power supply (not included) , power supply as optional
accessories. Please contact local dealer to require.
The recommended current capacity of your power supply is 12A.
1. Connect the DC power cable to the regulated DC power supply and ensure that the
polarities are correct. (Red: positive, Black: negative).
Do not directly connect the transceiver to an AC outlet.
Use the supplied DC power cable to connect the transceiver to a regulated power supply.
Do not substitute a cable with smaller gauge wires.
2. Connect the transceiver's DC power connector to the connector on the DC power cable.
Press the connectors firmly together until the locking tab clicks.
NOTE: Before connecting the DC power to the transceiver, be sure to switch the
transceiver and the DC power supply OFF.
Do not plug the DC power supply into an AC outlet until you make all connections.
09
Replacing Fuses
P2
If the fuse blows, determine the cause, then correct the problem. After the problem is
resolved, replace the fuse. If newly installed fuses continue to blow, disconnect the power
cable and contact your autho- rized TYT dealer or an authorized TYT servi-cecenter for
assistance.
Fuse Location
Transceiver
Supplied Accessory DC
power cable
Fuse Current Rating
15A
Only use fuses of the specified type and rating, otherwise the transceiver could be damaged.
NOTE: If you use the transceiver for a long period when the vehicle battery is not fully
charged, or when the engine is OFF, the battery may become discharged, and will not have
sufficient reserves to start the vehicle. Avoid using the transceiver in these conditions.
Power supply voltage Display
After connecting the transceiver to the power supply, the supply voltage can be displayed
on LCD by long pressing the key.
The display immediately changes as the voltage supply changes, It also displays voltage
during transmission.
20A