User's Manual

9.2 FCC Compliance

FCC Statement for cB-0701-01

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna

• Increase the separation between the equipment and receiver

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected

• Consult the dealer or an experienced radio/TV technician for help

Labeling Requirements for End Product

For an end product using the OEM Serial Port Adapter or the OEM Bluetooth Enabler there

must be a label containing, at least, the following information:

The label must be affixed on an exterior surface of the end product such that it will be visible

upon inspection in compliance with the modular approval guidelines developed by the FCC.

In addition, the user manual for the end product must contain the following information:

“This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired

operation.”

Antenna

When using the module equipped with the external antennas as described previously the

antenna is fixed and cannot be removed or replaced by the end user.

Caution

Any changes or modifications NOT explicitly APPROVED by connectBlue AB could cause

the module to cease to comply with FCC rules part 15, and thus void the user’s authority to

operate the equipment.

This device contains

FCC ID: PVH070101