User's Manual Part 2

11.2: GAP Commands Chapter 11: AT Commands Reference
38
Responses Description
<CR><LF>OK<CR><LF> Successful response.
<CR><LF>ERROR<CR><LF> Error response.
Model Constraint
cB-OEMSPA311
cB-OEMSPA331
cB-OEMSPA312
cB-OEMSPA332
Not supported. The module always allows a master slave switch
if requested by the remote side.
Get_RSSI (AT*AGRSS=)
AT Command Description
AT*AGRSS=<bd_addr><CR> This request returns the current received signal
strength, RSSI, for the connection between the ECI
Controller and the remote device identified by the
‘bd_addr’ parameter.
Note that this command can only be used on an exist-
ing connection that has been established using the
Connect_To_Serial_Service_Data_Mode command
and only while still in AT mode.
Command
Parameters
Type Value
bd_addr Bd_Addr Identifies a device that the Serial Port Adapter is
currently communicating with.
Responses Description
<CR><LF>*AGRSS:<rssi><CR><LF>OK<CR><LF> Successful response.
<CR><LF>ERROR<CR><LF> Error response.
Response
Parameters
Type Value
rssi integer < 128: The received signal strength is
128-RSSI dB below the optimal signal
range.
128: The received signal strength is
within the optimal signal range.
>128: The received signal strength is
RSSI-128 dB above the optimal signal
range.
Model Constraint
cB-OEMSPA311
cB-OEMSPA331
cB
-
OEMSPA312
Not supported.