User's Manual Part 2

11.4: Data Mode Commands Chapter 11: AT Commands Reference

Command

Parameters

Type Value

role_and_profile enumerator 0: DevB role, Serial Port Profile (default value)

1: Gateway role, Dial-Up Networking Profile

2: LAN Access Point role, LAN Access Profile

255: No profile.

store_in_startup_database enumerator 0: The setting will only be valid for the current

power cycle.

1: The Serial Port Adapter will remember the

setting between power cycles. The settings

database in the Serial Port Adapter will be

updated.

Responses Description

<CR><LF>OK<CR><LF> Successful response.

<CR><LF>ERROR<CR><LF> Error response.

Model Constraint

cB-OEMSPA311

cB-OEMSPA331

cB-OEMSPA312

cB-OEMSPA332

The LAN access profile is not supported.

If the current default server profile is “255: No profile”, the “store

in startup database” parameter must be 1 and the module must

be restarted for the command to take affect.

Read_Max_No_Of_Remote_Peers (AT*ADMRP?)

AT Command Description

AT*ADMRP?<CR> For some Serial Port Adapters it is possible to have more

than one remote peer defined. This command reads the

maximum number of allowed remote peers.

Responses Description

<CR><LF>*ADMRP:<max_no_of_remote_peers>

Successful response.

<CR><LF>ERROR<CR><LF> Error response.

Response Pa-

rameters

Type Value

max_no_of_remote_peers integer The maximum number of allowed re-

mote peers.

Model Constraint

cB-OEMSPA311

cB-OEMSPA331

cB-OEMSPA312

cB-OEMSPA332

Not supported. The parameter always has the value of one.