User's Manual Part 2

11.4: Data Mode Commands Chapter 11: AT Commands Reference
48
inactivety_tick integer 0: no inactivity tick (default value).
1-255: the period (in minutes) of the inactivity
timer.
Model Constraint
cB-OEMSPA311
cB-OEMSPA331
cB-OEMSPA312
cB-OEMSPA332
Not supported.
Write_Inactivity_Tick (AT*ADIT=)
AT Command Description
AT*ADIT=<inactivety_tick>,
<store_in_startup_database>
<CR>
This command writes a new inactivity tick setting. If there is no
data activity between two consecutive ticks the Serial Port
Adapter will automatically disconnect the current connection(s).
Command
Parameters
Type Value
inactivity_tick integer 0: no inactivity tick (default value).
1-255: the period (in minutes) of the inactivity
timer.
store_in_startup_database enumerator 0: The setting will only be valid for the current
power cycle.
1: The Serial Port Adapter will remember the
setting between power cycles. The settings
database in the Serial Port Adapter will be
updated.
Responses Description
<CR><LF>OK<CR><LF> Successful response.
<CR><LF>ERROR<CR><LF> Error response.
Model Constraint
cB-OEMSPA311
cB-OEMSPA331
cB-OEMSPA312
cB-OEMSPA332
Not supported.
Read_Wireless_Multidrop_Configuration
(AT*ADWM?)
AT Com-
mand
Description
AT*ADWM?<CR> This request returns whether or not the Wireless Multidrop™ fea-
ture has been enabled.
When the Wireless Multidrop™ has been enabled; all data sent to
the Serial Port Adapter in data mode will be forwarded to all con-
nected devices. Data received from a remote device will be for-
warded to the host. If the Auto_Forward parameter is set to TRUE
is will also forward all received data to all the other connected
devices.