User's Manual Part 2

11.6: Miscellaneous Commands Chapter 11: AT Commands Reference
52
parity enumerator 1: no parity (default value)
2: odd parity
3: even parity
flow_control enumerator 1: CTS/RTS used for flow control (default value)
2: CTS/RTS not used.
Model Constraint
cB-OEMSPA311
cB-OEMSPA331
cB-OEMSPA312
cB-OEMSPA332
For the non-standard baud rates the 312500 and 625000 has an
accuracy of 1.5% and 2.5 %. For all other baud rates the accu-
racy is no worse than 0.5 %.
Write_RS232_Settings (AT*AMRS=)
AT Command Description
AT* AMRS=<baud_rate>, <data_bits>, <stop_bits>,
<parity>, <flow_control>, <change_after_confirm>,
<store_in_startup_database><CR>
This command applies new RS232
settings to the Serial Port Adapter. If 5,
6 or 7 data bits are selected the Serial
Port Adapter will not change its RS232
settings until the next power cycle
Command
Parameters
Type Value
baud_rate enumerator See Read_RS232_Settings.
data_bits enumerator See Read_RS232_Settings.
stop_bits enumerator See Read_RS232_Settings.
parity enumerator See Read_RS232_Settings.
flow_control enumerator See Read_RS232_Settings.
change_after_confirm enumerator 0: The Serial Port Adapter will not change
RS232 settings until after the next power cycle.
1: The Serial Port Adapter will change RS232
settings after it has sent the OK to the ECI
Host.
store_in_startup_database enumerator 0: The setting will only be valid for the current
power cycle.
1: The Serial Port Adapter will remember the
setting between power cycles. The settings
database in the Serial Port Adapter will be
updated.
Responses Description
<CR><LF>OK<CR><LF> Successful response
<CR><LF>ERROR<CR><LF> Error message.
Read_Serial_Interface_Type (AT*AMSIT?)
AT Command Description
AT*AMSIT?<CR> This command reads the serial interface type currently used.