User's Manual Part 2

11.6: Miscellaneous Commands Chapter 11: AT Commands Reference
53
Responses Description
<CR><LF>*AMSIT:<serial_interface_type>
<CR><LF>OK<CR><LF>
Successful response
<CR><LF>ERROR<CR><LF> Error message.
Response
Parameters
Type Value
serial_interface_type enumerator 1: RS232 (default value)
2: RS422
3: RS485
4-255: Reserved for future use.
Write_Serial_Interface_Type (AT*AMSIT=)
AT Command Description
AT*AMSIT=<serial_interface_type>,
<store_in_startup_database><CR>
This command writes the serial interface type cur-
rently used.
Note that the Serial Port Adapter does not change
serial interface type until the next time it is restarted.
Command
Parameters
Type Value
serial_interface_type enumerator See Read_Serial_Interface_Type.
store_in_startup_database enumerator 0: The setting will only be valid for the current
power cycle.
1: The Serial Port Adapter will remember the
setting between power cycles. The settings
database in the Serial Port Adapter will be up-
dated.
Responses Description
<CR><LF>OK<CR><LF> Successful response
<CR><LF>ERROR<CR><LF> Error message.
Read_Favorites (AT*ACF?)
AT Command Description
AT*ACF?<CR> Read the stored favorites.
Responses Description
<CR><LF>*ACF:<no_of_stored_favorites>
<CR><LF>OK<CR><LF>
Successful response
*ACFD:<bd_addr>,<favorite_name><CR><LF> This response is sent for every
found favorite device.
<CR><LF>ERROR<CR><LF> Error message.