User's Manual Part 2

11.6: Miscellaneous Commands Chapter 11: AT Commands Reference

AT*AMMP=<max_output_power>,

<store_in_startup_database><CR>

Set the maximum output power to be used by

the Serial Port Adapter when communicating.

Note that not all Serial Port Adapter models

support output power control.

Command Pa-

rameters

Type Value

max_output_power integer See Read_Max_Output_Power.

store_in_startup_database enumerator 0: The setting will only be valid for the current

power cycle.

1: The Serial Port Adapter will remember the

setting between power cycles. The settings

database in the Serial Port Adapter will be

updated.

Responses Description

<CR><LF>OK<CR><LF> Successful response

<CR><LF>ERROR<CR><LF> Error message.

Model Constraint

cB-OEMSPA311

cB-OEMSPA331

cB-OEMSPA312

cB-OEMSPA332

Not supported.

Read_Esc_Sequence_Timing (AT*AMET?)

AT Command Description

AT*AMET?<CR> For an escape sequence to be valid, a period of no

data activity is required before and after the escape

sequence. This command reads the minimum time of

no data activity required before and after the escape

sequence.

Responses Description

Successful response

<CR><LF>ERROR<CR><LF> Error message.

Response Parame-

ters

Type Value

min_before_time integer 50-5000 ms.

The default value is 1000.

min_after_time integer 50-5000 ms.

The default value is 1000.