User's Manual Part 2

11.6: Miscellaneous Commands Chapter 11: AT Commands Reference
60
Model Constraint
cB-OEMSPA311
cB-OEMSPA331
cB-OEMSPA312
cB-OEMSPA332
Not supported.
Write_Button_Operation_Mode (AT*AMBO=)
AT Command Description
AT*AMBO=<button_id>, <operation_mode>,
<general_parameter>,
<store_in_startup_database><CR>
For some Serial Port Adapters it is possible to
select the operation that shall be associated with
a specific button.
Command Pa-
rameters
Type Value
button_id integer See Read_Button_Operation_Mode.
operation_mode integer See Read_Button_Operation_Mode.
general_parameter integer See Read_Button_Operation_Mode.
store_in_startup_database enumerator 0: The setting will only be valid for the current
power cycle.
1: The Serial Port Adapter will remember the
setting between power cycles. The settings
database in the Serial Port Adapter will be
updated.
Responses Description
<CR><LF>OK<CR><LF> Successful response
<CR><LF>ERROR<CR><LF> Error message.
Model Constraint
cB-OEMSPA311
cB-OEMSPA331
cB-OEMSPA312
cB-OEMSPA332
Not supported.
Read_LED_Operation_Mode (AT*AMLO?)
AT Command Description
AT*AMLO?<CR> For some Serial Port Adapters it is possible to select
an alternate operation mode for control of LEDs.
Responses Description
<CR><LF>*AMLO: <operation_mode>, <gen-
eral_parameter><CR><LF>OK<CR><LF>
Successful response
<CR><LF>ERROR<CR><LF> Error message.