User's Manual Part 2

11.6: Miscellaneous Commands Chapter 11: AT Commands Reference
61
Response Parame-
ters
Type Value
operation_mode integer The new LED operation mode
(1=default).
general_parameter integer The meaning of this parameter de-
pends on the value of the opera-
tion_mode parameter.
Model Constraint
cB-OEMSPA311
cB-OEMSPA331
cB-OEMSPA312
cB-OEMSPA332
Not supported.
Write_LED_Operation_Mode (AT*AMLO=)
AT Command Description
AT*AMLO=<operation_mode>, <gen-
eral_parameter>,
<store_in_startup_database><CR>
For some Serial Port Adapters it is possible to
select an alternate operation mode for control of
LEDs.
Command Pa-
rameters
Type Value
operation_mode integer See Read_LED_Operation_Mode.
general_parameter integer See Read_LED_Operation_Mode.
store_in_startup_database enumerator 0: The setting will only be valid for the current
power cycle.
1: The Serial Port Adapter will remember the
setting between power cycles. The settings
database in the Serial Port Adapter will be
updated.
Responses Description
<CR><LF>OK<CR><LF> Successful response
<CR><LF>ERROR<CR><LF> Error message.
Model Constraint
cB-OEMSPA311
cB-OEMSPA331
cB-OEMSPA312
cB-OEMSPA332
Not supported.
Store_Factory_Settings (AT*AMSF)
AT Command Description
AT*AMSF<CR> Store all the current settings in the factory set-
tings database. The factory settings can be
restored using the AT&F command.