User's Manual Part 2

11.6: Miscellaneous Commands Chapter 11: AT Commands Reference
63
Write_Watchdog_Settings (AT*AMWS=)
AT Command Description
AT*AMWS=<bt_write_timeout>,
<bt_inactivity_timeout>,
<bt_connect_timeout>,
<bt_disconnect_reset>, <reset>,
<store_in_startup_database><CR>
Write watchdog parameters. The watchdog
functionality is only active in data mode and not
AT or ECI mode. Furthermore, the power mode
must also be set to online (see AT*AMPM).
Command Pa-
rameters
Type Value
bt_write_timeout integer Time in seconds before SPA disconnects if out
of credits.
0: Disabled (default value)
> 0: Timeout in seconds
bt_inactivity_timeout integer Time in seconds before SPA disconnects if no
activity.
0: Disabled (default value)
> 0: Timeout in seconds
bt_connect_timeout integer Max connection time in seconds before a
connection is terminated.
0: Disabled (default value)
> 0: Timeout in seconds
bt_disconnect_reset integer 0: Disabled (default value)
1: An SPA enabled, as a server will reset on a
terminated connection.
reset integer If set to 1 the SPA will reset immediately. All
other parameters will be ignored.
store_in_startup_database enumerator 0: The setting will only be valid for the current
power cycle.
1: The Serial Port Adapter will remember the
setting between power cycles. The settings
database in the Serial Port Adapter will be
updated.
Responses Description
<CR><LF>OK<CR><LF> Successful response
<CR><LF>ERROR<CR><LF> Error message.
Model Constraint
cB-OEMSPA311
cB-OEMSPA331
cB-OEMSPA312
cB-OEMSPA332
Only implemented to reset the module. All other parameters are
ignored.
Read_DTR_DSR_Settings (AT*AMDS?)
AT Command Description
AT*AMDS?<CR> Read current DTR/DSR configuration.