User's Manual

Version 1.0 - 2006-08 33
7.2 Safety Compliance
In order to fulfill the safety standard EN 60950-1 the unit must be supplied by a limited power
source.
7.3 FCC and IC Compliance
See Table 1 for information about the different product variants.
7.3.1 Compliance for cB-0905-0202
7.3.1.1 FCC Statement for cB-0905-0202
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
Consult the dealer or an experienced radio/TV technician for help
7.3.1.1.1 Antenna
Our module type cB-0905-0202 is for OEM integrations only. The end-user product will be
professionally installed in such a manner that only the authorized antennas are used.
7.3.1.1.2 Caution
Any changes or modifications NOT explicitly APPROVED by connectBlue AB could cause the
module to cease to comply with FCC rules part 15, and thus void the user’s authority to operate
the equipment.
7.3.1.2 IC Compliance
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
List of approved antennas:
• 2.4 GHz Flying Lead Straight Antenna IHF-242
• WCR-2400-IP04
• MicroBlue CAP24235
•
NanoBlue-IP04