User's Manual

BS301RK
TWS Bluetooth Headset
User Manual
1）Charging Base Type-C
2）Charing Base Indicator
3）Headset Indicator & Mic Hole
4）Speaker
5）Touch Panel
Step
②
Slightly rotate headset until firm
Step
③
Make the headset to cochlear edge tightly
Type-C charging port
Use the Type-C cable to connect with computer
Use the Type-C cable to connect
with mobile phone charger
Headset (R)Headset (L)
Erect headset and place
them into the cochlea
Wear the headset (R) and
headset (L) respectively
3
5
1
2
4
Please use Type-C to charge.
The indicator will stop flashing after
being fully charged.
Specifications
*The time mentioned above may vary due to user's operation mode and
device settings.
Bluetooth Version：
Bluetooth Profiles Supported：
Audio Decoding Protocol：
Transmission Power：
Operation Range：
Frequency Range：
Battery of Headset：
Charging Voltage of Headset：
Charging Time of Headset：
Battery of Base：
Charging Voltage of Base：
Charging Time of Base：
Charging Headset Times from
Charging Base：
Music Playing Time：
Talk Time：
Standby Time：
Driver：
Driver sensitivity ：
Driver impedance：
Driver frequency ring range：
Dimensions of Charging
Base(mm)：
Dimensions of Headset(mm)：
Weight(one headset)：
Total Weight ：
V5.0
HFP, HSP, A2DP, AVRCP
SBC, AAC, APTX,CVC
Class 2
Up to 10 meters
2.4GHz-2.48GHz
40mAH Li-polymer Battery
DC 5V±0.2V
About 1.5 hours
400mAH Li-polymer Battery
DC 4.5 V-6.0 V
About 1.5 hours
About 2-3 times
≥ 4.5 hours
≥ 5 hours
≥ 100 hours
φ10mm
93±3dB (1KHz)
16Ω±15％
20Hz-20KHz
L51.5×W51.5×H21.1
L43.1×W16.6×H17.2
About 3.4 g
About 37.2 g
To Know Your Headsets
Step
①
How To Wear:
How To Charge The Headset
The indicator is white when
being charged, will turn off
automatically after being fully
charged.
Note: When the battery power
is lower than 10%, the headset
will remind you of “low battery
please charge” every 60
seconds.
How To Charge The Charging
Base
Turning ON/OFF
Method
Pick up the headsets from the charging base to turn on
automatically.
Put them back to power off and charge the headsets.
Method
Status No.
Status No.
Status
Status Charging Base Performance
Headset Performance
1
1
2
2
3
5
4
TWS Pairing Mode
Headset Charging
Power Off
Headset Indicator
The indicator flashes white quickly
Power On
The indicator is white when being charged, will turn
off automatically after being fully charged.
Touch the touch panel of headset(R) or headset(L) for 2 seconds
to turn on.
Touch the touch panel of headset(R) or headset(L) for 5 seconds
to turn off.
Bluetooth headset should be used with the compatible devices which
support Bluetooth wireless technology. This allows you to make two
calls and enjoy the music streaming at any time freely.Please read
this user manual carefully before using the headset, and also read
your device’s user manual regarding the Bluetooth function, and pay
attention to those important safety and maintenance information.
Please keep the headset away from children.
Put the headset (L) (R) to the corresponding position in the bottom
of the charging base.
Check the charging device is suitable for the headset or not.
Use only the supplied charger to charge the headset, if use other
device may violate the validation or the maintenance article of this
product and may cause danger.
Do not attempt to force open the built-in battery as this could damage
the headset.
A fully charged headset will loseits power automatically if left unused.
It is recommended to charge the headset every three months.
Do not leave the headset in a too hot or too cold condition (best
between -10℃ and 50℃) which may affect the headset's operations
although it is fully charged.
Do not dispose of the headset into fire or water.
Note 1:
Note 2:
Note 3:
Note 4:
Note 5:
Note 6:
Charging Base Indicator
Ready for pairing
to phone
After TWS paired,right headset flashes white slowly,
left headset flashes white once each 5 seconds.
The indicator flashes white for 3 times.
The indicator flashes white for 3 times
Charging
Working
1.When using USB to charge, the indicator flashes red
2.The indicator will stop flashing after being fully charged
3.The indicator will turn off if it is not charging
Note: Please charge the base and headsets before usage
The indicator light flashes red each 2 seconds, once
means 0%-25% battery, twice means 25%-50%, 3 times
means 50%-75%, 4 times means75%-100%