QUICK START GUIDE Ice Makers • 115 V / 60 Hz & 220-240 V / 50 Hz
QUICK START GUIDE u-line.com WELCOME TO U-LINE Congratulations on your U-Line purchase. Your product comes from a company with over five decades and three generations of premium modular ice making, refrigeration, and wine preservation experience. U-Line continues to be the American leader, delivering versatility and flexibility for multiple applications including residential, light commercial, outdoor and marine use.
QUICK START GUIDE u-line.com This Quick Start Guide covers the basics of installation and general use of your product. For more details, see the complete User Guide & Service Manual on u-line.com.
QUICK START GUIDE u-line.com Safety and Warning that they do not play with this appliance. Cleaning and NOTICE without supervision. user maintenance shall not be performed by children PLEASE READ all instructions before installing, operating, or servicing the appliance. ! DANGER SAFETY ALERT DEFINITIONS Do not use electrical appliances inside the food Throughout this guide are safety items labeled with a storage compartment of this appliance.
QUICK START GUIDE u-line.com This appliance is intended to be used in household and ! CAUTION similar applications such as: Use care when moving and handling the unit. • Staff kitchen areas in shops, office and other working Use gloves to prevent personal injury from sharp environments. edges. • Farm houses and by clients in hotels, motels and other If your model requires defrosting, DO NOT use residential type environments. medical devices or other means to accelerate the defrosting process.
QUICK START GUIDE u-line.com 220-240 V UNITS ! CAUTION This model is intended for indoor/interior applications only and is not to be used in installations that are open/ Damages caused by ambient temperatures of exposed to natural elements. 40°F (4°C) or below are not covered by the warranty. This unit is designed to operate between 50°F (10°C) and 90°F (32°C). Higher ambient temperatures may reduce the unit’s ability to reach low temperatures and/or reduce ice production on applicable models.
QUICK START GUIDE u-line.com The unit requires a grounded and polarized 115 VAC, The unit requires a grounded and polarized 230 VAC, 60 Hz, 15A power supply (normal household current). An 50 Hz, 8A power supply (normal household current). An individual, properly grounded branch circuit or circuit individual, properly grounded branch circuit or circuit breaker is recommended. A GFCI (ground fault circuit breaker is recommended.
QUICK START GUIDE u-line.com 1. Turn off water supply and disconnect electrical supply • The water line MUST have a shut-off valve in the to product prior to attempting installation. supply line. 2. Remove the grille (plinth strip/base fascia) and access • The water line should be looped into 2 coils. This will panel (if equipped) along with back panel. allow the unit to be removed for cleaning and servicing. Make certain that the tubing is not pinched or damaged during installation. 3.
QUICK START GUIDE u-line.com 6. Turn on water supply and check for leaks. Water Supply Connection 7. Reinstall the grille (plinth strip/base fascia) and access following: When connecting the water supply, please note the panel (if equipped) along with the back panel. • Before installing the unit and connecting to the cold water supply, review the local plumbing codes. 8. Install retaining clip. • The water pressure should be between 20 and 120 psi (138 and 827 kPa).
QUICK START GUIDE u-line.com 7. Turn on water supply and check for leaks. ! CAUTION 8. Reinstall back panel. Turn off water supply and disconnect electrical supply to unit prior to installation. 9. Install retaining clip. Use caution when handling back panel. The edges could be sharp. 1. Turn off water supply and disconnect electrical supply to product prior to attempting installation. 2. Remove the back panel. 3. Locate water valve inlet. Door Swing 1200 SERIES Wall Wall 1/4" Min. (6 mm) 4.
QUICK START GUIDE u-line.com Door Latch Stainless Steel and black and white models require 2-1/8" (54 mm) door clearance to accommodate the handle if MARINE MODELS installed next to a wall. The door latch assembly included with your unit can be installed to prevent the door from opening when the Integrated models require 1/4" (6 mm) clearance if vehicle is in motion. installed next to a wall. Allow for additional space for any knobs or pulls installed on the integrated panel/frame.
QUICK START GUIDE u-line.com General Installation 1200 SERIES LEVELING INFORMATION MARINE AND BI SERIES 1. Use a level to LEVELING INFORMATION confirm the unit is NOTICE level. Level should Because these units do not have leveling legs, it be placed along top edge and side edge is extremely important that they sit on a level as shown. surface. If they are not level, the ice mold will not fill evenly. 1 Use a level to confirm the unit is level.
QUICK START GUIDE u-line.com INSTALLATION 2. Pull door gasket out of groove (top edge of door only). Start in 1. Plug in the power/electrical cord. the middle and pull outward, moving toward the edge. This 2. Gently push the unit into position. Be careful not to may take some force. kink the water supply line or entangle the cord. 3. Re-check the leveling, from front to back and side to side. Make any necessary adjustments. The unit’s top 3.
QUICK START GUIDE u-line.com CRESCENT ICE MAKERS AND ADA15IM Due to differences in floor construction or 1. Fully open door/drawer. surrounding cabinetry, the panel may not sit flush with the top of the door/drawer. 2. Starting at corner, pull gasket away from door/ Panel Door drawer. 3. Continue to pull gasket free from gasket channel. 9. Secure integrated panel to door/drawer 4. Upon removal, lay gasket Bar Clamp using clamps. A down on a flat surface. robust tape may also be used.
QUICK START GUIDE u-line.com Ice 13.Be sure the screws force their way past the opening on the gasket channel and sit flush against the bottom of ICE MAKER OPERATION the channel. When the ice bucket is full, the ice making mechanism will shut off. However, the refrigeration system will continue to cool and maintain the ice supply. Integrated Panel NOTICE Integrated Panel Do not place cans or bottles in the ice compartment because they will freeze. 14.Remove clamps from door/drawer.
QUICK START GUIDE u-line.com During periods of limited use or high ambient temperatures, it is common for cubes to fuse together. Gently shake the bucket to break apart cubes. If not using the ice maker regularly, empty the ice bucket periodically to ensure fresh cubes. It is normal for cubes to appear cloudy. The cause is air trapped in the water because of fast freezing. It is not caused by the health, taste or chemical make up of the water. It is the same air that is in every glass of water you drink.
U-Line Corporation (U-Line) Limited Warranty One Year Limited Warranty For one year from the date of original purchase, this U-Line product warranty covers all parts and labor to repair or replace any part of the product that proves to be defective in materials or workmanship. For products installed and used for normal residential use, material cosmetic defects are included in this warranty, with coverage limited to 60 days from the date of original purchase.