- Use and Care Guide - 1115WC, 1175WC

18 1115WC, 1175WC
Figure 28
5. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge (Figure 28) . Do not
install hinge on cabinet at this time.
Figure 29
6. Remove bottom hinge from cabinet (four screws) and
screws on opposite side of cabinet (Figure 29) .
7. Remove pivot screw from bottom hinge, invert screw
and reinstall pivot screw in hinge (Figure 28) .
Figure 30
8. Install bottom hinge on cabinet, opposite side, aligning
flat edge of hinge with outer edge of unit (Figure 30) .
Partially tighten screws.
Figure 31
9. Relocate plastic spacer/bushing (Figure 31) on bottom
of door to the opposite side. Clean out bushing hole in
door bottom if necessary.
Figure 32
10.Place door on lower hinge pin. Align flat edge of top
hinge with outer edge of unit and fasten upper hinge
to unit (four screws) (Figure 32) . Partially tighten
screws until door is aligned.
11.Adjust door to assure proper seal. Tighten upper and
lower hinge screws securely.
12.Replace four plastic plugs removed in Step 4 into holes
on top of unit. Replace screws in holes in bottom of unit
on opposite side.
13.Replace the grille.
Plastic
Plug Hole
Plastic
Plug Hole
Hinge
Screw
Right Side
Door Swing
Right Side
Hinge
Invert
Screw
Invert
Hinge
Left Side
Door Swing
ULIN_0106_A
ULIN_0107_A
ULIN_0160_A
1
ULIN_0109_A
ULIN_0110_A
ULIN_016357_30088.fm Page 18 Tuesday, March 14, 2006 2:17 PM