QUICK START GUIDE 1000 Series • CLR1215 • 115 V / 60 Hz
QUICK START GUIDE u-line.com WELCOME TO U-LINE Congratulations on your U-Line purchase. Your product comes from a company with over five decades of premium modular ice making, refrigeration, and wine preservation experience. U-Line continues to be the American leader, delivering versatility and flexibility for multiple applications including residential, light commercial, outdoor and marine use.
QUICK START GUIDE u-line.com This Quick Start Guide covers the basics of installation and general use of your product. For more details, see the complete User Guide & Service Manual on u-line.com. Contents 1. Safety and Warning 2. Environmental Requirements 3. Electrical 3. Water Hookup 5. Drain 6. Door Swing 7. Door Adjustments 9. General Installation 9 . Integrated Panel Installation 11. Control Operation 11. First Use 11.
QUICK QUICK START START GUIDE GUIDE u-line.com u-line.com Safety and Warning ! DANGER NOTICE This unit contains R600a (Isobutane) which is a Please read all instructions before installing, flammable hydrocarbon. It is safe for regular operating, or servicing the appliance. use. Do not use sharp objects to expedite defrosting.
START GUIDE GUIDE QUICK START u-line.com u-line.com Environmental Requirements OUTDOOR UNITS This unit is designed to operate between 50°F (10°C) and 115 V UNITS 100°F (38°C). Higher ambient temperatures may reduce This model is intended for indoor/interior applications only the unit’s ability to reach low temperatures and/or reduce and is not to be used in installations that are open/ ice production on applicable models. exposed to natural elements.
QUICK QUICK START START GUIDE GUIDE u-line.com u-line.com Electrical Water Hookup PREPARE PLUMBING ! WARNING The water valve uses a standard 1/4" (6.35 mm) compression fitting. U-Line recommends using accessory SHOCK HAZARD — Electrical Grounding water hookup kit - part # WATERHOOKUP. The kit Required. Never attempt to repair or perform includes a 10’ (3 mm) braided flexible water supply line maintenance on the unit until the electricity has and a brass hose fitting. been disconnected.
START GUIDE GUIDE QUICK START u-line.com u-line.com 4. On the back panel, ! CAUTION break away filler feature in bushing with flat Do not use any plastic water supply line. The line screwdriver. is under pressure at all times. Plastic may crack or rupture with age and cause damage to your Remove ZLWK ɠDW screwdriver home. Do not use tape or joint compound when attaching a braided flexible water supply line 5. Thread water line that includes a rubber gasket.
QUICK START START GUIDE GUIDE u-line.com u-line.com Drain GRAVITY DRAIN Model numbers including “-00” or “-07” do not include a factory installed drain pump. Normal Proper Drain Model numbers including “-40” or “-47” include a factory installed drain pump.
QUICK QUICK START START GUIDE GUIDE u-line.com u-line.com FACTORY INSTALLED DRAIN PUMP Y-Branch Tailpiece P60 Pump Required If your drain line will run up to a stand pipe, disposal or Air Gap (Optional Hook-Up) spigot assembly, or does not otherwise meet the requirements for a gravity drain, you may have ordered a pre-installed U-Line P60 drain pump. Waste If you need to install a P60 drain pump into your unit, see 6KXW 2ɞ Valve DRAIN PUMP section in the User Manual.
QUICK QUICK START START GUIDE GUIDE u-line.com u-line.com Door Adjustments DOOR ALIGNMENT AND ADJUSTMENT 15” Models These general instructions apply to all models. For further details, see user guide for your specific model at u-line.com. Align and adjust the door if it is not level or is not sealing properly. If the door is not sealed, the unit may not cool properly, or excessive frost may form in the interior.
QUICK START START GUIDE GUIDE u-line.com u-line.com 3. Remove door by tilting forward and lifting door off 2. Remove magnet assembly from door with T-10 TORX bottom hinge. Retain shoulder washers; they will driver. Be sure to only remove the two screws holding be reused. the assembly to the door. Reinstall on the opposite end of the door 4. Remove three screws from hinge holes on the opposite side. Reinstall into holes where the hinge was 3. Rotate gasket 180°, aligning notch with magnet removed.
QUICK START STARTGUIDE GUIDE QUICK u-line.com u-line.com General Installation INSTALLATION 1. Plug in the power/electrical cord. LEVELING INFORMATION 2. Gently push the unit into position. Be careful not to 1. Use a level to entangle the cord or water and drain lines. confirm the unit is level. Level should 3. Re-check the leveling, from front to back and side to be placed along top edge and side edge side. Make any necessary adjustments. The unit’s top as shown.
QUICK START START GUIDE GUIDE QUICK u-line.com u-line.com It is important to ensure that all drilled holes are 8. Align door with cabinet. Tighten the top 3 screws, drilled to the correct depth in order to avoid securing the top hinge to the cabinet. splits in the wood when hardwood is installed. 11.Locate 6 of the #6x 1-1/4" (32 mm) screws provided Align Top Of Panel With Highest Point Of Door/Drawer with your unit. Align Panel Against Door/Drawe Edge First 12.
QUICK START GUIDE QUICK START GUIDE USER GUIDE u-line.com u-line.com u-line.
QUICK START GUIDE u-line.com u-line.com The ice cube thickness is factory set for best overall Your clear ice machine is pre-set to produce ice between performance. The factory setting is designed to maintain the optimal dimensions illustrated below: Cube Details an ice bridge of approximately 1/16" to 1/8" (1.6 mm to 3.2 mm) under normal conditions, resulting in a dimple of 1/4" TO 1/2" (6.4 mm to 12.7 mm) DIMPLE approximately 1/4" to 1/2" (6.4 mm to 12.7 mm) in depth.
U-Line Corporation (U-Line) Limited Warranty One Year Limited Warranty For one year from the date of original purchase, this warranty covers all parts and labor to repair or replace any part of the product that proves to be defective in materials or workmanship. For products installed and used for normal residential use, material cosmetic defects are included in this warranty, with coverage limited to 60 days from the date of original purchase.
