ULIN_016357_30096.
1 Introduction Congratulations on your purchase of a U-Line refrigeration product. A pioneer in the field for more than 40 years, U-Line Corporation is the world’s number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-Line dedicates 100% of its research and development to these products. The result: U-Line technology consistently leads the market with innovation, design, depth of product line and performance.
2 Table of Contents Introduction ...............................................................................................................................2 Warranty Registration .......................................................................................................2 Please Record Your Model Information ...........................................................................2 Table of Contents ...........................................................................................
This page intentionally left blank 4 CLR2160, CLRCO2175
WARNING 3 Safety Precautions IMPORTANT PLEASE READ all instructions completely before attempting to install, operate, or service your unit. • Proper installation procedures must be followed if this unit is being initially installed, or is moved to a new location after being in service. An INSTALLATION GUIDE for your unit, providing complete installation information is available from U-Line Corporation directly, and must be consulted before any installation is begun.
Exclusive Features of Échelon 4 Product Features Échelon Model CLR2160 Clear Ice Maker, Model CLRCO2175 Clear Ice Maker/Refrigerator CLR2160 • This model produces up to 60 lbs (27.2 kg) of ice per day, will store 30 lbs (13.6 kg). • An easy, self-cleaning process for the clear ice maker eliminates complicated procedures. • Black and white models feature a slightly contoured, across the top, integrated door handle design that permits the door to be easily reversed.
Temperature Control 5 Operation Checking Product Temperature ULIN_0080_A Figure 2 IMPORTANT Proper air flow (Figure 2) is required for your unit to operate at its highest efficiently. A grille, located in the base of the unit, must not be blocked at any time, or your unit will not perform as expected. ULIN_0093_A Initial Startup All U-Line units are shipped with controls that are preset. No initial adjustments are required.
Interior Lighting Temperature Display The interior of Model CLR2160 is not illuminated. The refrigerator section of Model CLRCO2175 is illuminated whenever the door is opened. To display the Model CLRCO2175 interior temperature: The LIGHT icon (Figure 3, 5) on the control panel is used to control an additional Model CLRCO2175 lighting function. The blackout/Sabbath mode (not Star K certified) will turn the interior light and display (Figure 3, 3) off.
Normal Operating Sounds Storage, Vacation, Moving All models incorporate rigid foam insulated cabinets to provide high thermal efficiency and maximum sound reduction for its internal working components. In spite of this technology, your model may make sounds that are unfamiliar. If the unit will not be used for an extended period, or otherwise stored, follow these steps completely: Normal operating sounds may be more noticeable because of the unit’s environment.
Product Disposal 6 Cleaning and Maintenance If the unit is being removed from service for disposal, check and obey all Federal, State and/or Local regulations regarding the disposal and recycling of refrigeration appliances, and follow these steps completely: General Cleaning 1. Disconnect power to the unit and unplug the power cord from its outlet. Black and White Models: 2. Shut off water supply to the unit at the main water source and disconnect the supply line to the unit’s water valve.
Maintenance To defrost: Proper maintenance of your U-Line product will ensure efficiency, top performance and long life. The maintenance intervals listed are based on normal conditions. You may want to shorten the intervals if you have pets or other special considerations. 1. Turn unit off. Defrosting Automatic (Cycle) Defrost and Frost-Free Models These models do not produce frost in normal operating conditions.
CAUTION 1 2 3 4 5 DO NOT use any type of cleaner on the condenser unit. 4. Clean the condenser coil (Figure 8, 2) using a soft brush with a “combing” action or vacuum cleaner. Do not touch the condenser coil. 5. Position the grille to align the mounting screws with the holes in the cabinet. 6. Secure, but do not over-tighten both grille screws. ULIN_0058_A Figure 9 1. Turn the ice maker off (allowing any ice to melt off of the evaporator) as follows: a.
it from the drain hole. The water in the reservoir will flow down the drain. 2 3 5. Replace the overflow tube after all of the water has drained from the reservoir. 6. Start the cleaning cycle as follows: a. Touch and hold the ON/OFF button (Figure 9, 1). b. Touch and release the LIGHT button (Figure 9, 4) three times, then release the ON/OFF button (Figure 9, 1). c. The display (Figure 9, 3) will show “CL” to confirm the beginning of the cleaning cycle. 7.
b. Touch and release the DOWN ARROW (Figure 13, 2) button three times, then release the UP ARROW button (Figure 13, 1). c. The display (Figure 13, 3) will switch to “0” to confirm the thickness adjustment mode has been selected. 2. The factory setting is “0,” and the total range of adjustment is -5 to +5. Use the UP ARROW button to raise the setting and thicken the ice bridge, or the DOWN ARROW button to lower the setting to thin the ice bridge.
Door Alignment Check and Adjustment IMPORTANT When properly aligned: 1 • The door will not be flush with the top of the cabinet. The top edge of the door will be 1/8 in. (3.175 mm) below the cabinet top. • The door gasket will be firmly in contact with the perimeter of the cabinet and not pinched on the hinge side of the door. The following procedure will correct for up to 1/4 in. misalignment: 2 3 ULIN_0201_A Figure 20 3. Turn the door upside down and inspect the hinge plate mounting holes.
Door Reversal 1 ULIN_0002_A Figure 24 2. Remove plastic screw plugs (three each, top and bottom) (Figure 24, 1) from new hinge location. Do not discard. 3. Remove top hinge (three screws) (Figure 23, 2) and reinstall hinge screw pin (Figure 23, 1). ULIN_0015_A Figure 22 Black and white units may be left- or right-hand opening. Stainless steel unit doors cannot be reversed. The doors are easily reversed by moving the hinge hardware to the opposite side.
5. Remove the two door closer inserts (Figure 26, 1) from the existing bottom hinge and install as shown on the new bottom hinge (Figure 25, 1). Door Shelf Removal/Insertion 6. Remove existing bottom hinge (three screws) and remount on opposite side TOP. Remove hinge screw pin. 1 7. Remove the plastic hole plug from the top of the door to allow the pivot pin to be inserted in the new location. Install the plug into the vacated hole on the opposite side.
Insert the shelves as follows: Light Bulb Replacement 1. To move to a different position in the unit, insert shelf at an angle, approximately 15-20°, over the rib in the side of the unit where you want to place the shelf. The shelf must be started into the unit at an angle to clear the door. CLRCO2175 To replace the light bulb in your U-Line unit: 2. Continue to slide the shelf into the unit at an angle until it clears the door. 1 2 3. Lower the shelf and push it in completely.
7 Service Before Calling for Service If your U-Line product appears to be malfunctioning, read through the OPERATION section of this guide to ensure that the function of all controls are clearly understood. If the malfunction persists, the TROUBLESHOOTING GUIDE in this guide will assist you in quickly identifying common problems, and provide information on possible causes and remedies. Most often, this will resolve the problem without the need to call for service.
Troubleshooting Guide NOTE: Recommended refrigerator temperature setting is 38°F. DANGER ELECTROCUTION HAZARD Never attempt to repair or perform maintenance on the unit until the main electrical power has been disconnected. Troubleshooting - What to check when problems occur: PROBLEM POSSIBLE CAUSE REMEDY Unit does not operate and electronic display is blank. No electrical supply Plug unit in or check circuit breaker. Low air temperature around unit Surrounding air temperature must be at least 50°F.
PROBLEM POSSIBLE CAUSE REMEDY Unit runs but produces very little ice. Dirty condenser coils Clean the condenser (See MAINTENANCE; CONDENSER CLEANING). High air temperature around unit Surrounding air temperature of over 90°F. Low ice production at high temperatures is normal. Scale and mineral buildup in unit Run unit through self cleaning cycle (See MAINTENANCE; ICE MAKER: SELF CLEANING CYCLE. Inadequate airflow at the front of the unit Remove items blocking airflow.
Electronic Control Quick Guide All Models Task Touch Turn ON/OFF Adjust Temperature Hold 10 seconds Touch Display Release when °F flashes. or or or Touch and release Touch to change temperature View Actual Temperature (T1) Hold 5 seconds Change °F-°C Hold Blackout Mode °F flashes after first touch, set-point saved after 5 seconds of inactivity and °F stops flashing. (For Wine Cooler Only) Will scroll top/middle/bottom temperatures. Release when °F flashes.
U-Line Corporation Limited Warranty U-Line Corporation warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, the evaporator, the hot gas bypass valve, the dryer and the connecting tubing) in each U-Line product to be free from defects in materials and workmanship for a period of five years from the date of purchase.
For General Inquiries: P.O. Box 245040 Milwaukee, Wisconsin 53224-9540 U.S.A. Phone (800) 779-2547 FAX (414) 354-5696 www.U-Line.com For Service and Parts Assistance: Phone (800) 779-2547 (414) 354-0300 FAX (414) 354-5696 Email: OnLineService@U-Line.com www.U-LineService.com E-mail: OnlineParts@u-line.com For more than four decades, U-Line has distinguished itself as the leader in built-in under-counter ice making, refrigeration and wine storage appliances.
