QUICK START GUIDE Combo® Models • 115 V / 60 Hz
QUICK START GUIDE u-line.com WELCOME TO U-LINE Congratulations on your U-Line purchase. Your product comes from a company with over five decades and three generations of premium modular ice making, refrigeration, and wine preservation experience. U-Line continues to be the American leader, delivering versatility and flexibility for multiple applications including residential, light commercial, outdoor and marine use.
QUICK START GUIDE Contents 1 Model List 2 Safety and Warning 2 Environmental Requirements 3 Electrical 3 Water Hookup 5 Door Swing 6 General Installation 7 Integrated Panel Installation 10 Control Operation 11 First Use 11 Ice 12 Sabbath Mode 12 Warranty u-line.
QUICK START GUIDE u-line.com Model List This guide provides the basics to get you started. Looking for more information? Visit u-line.com to view detailed User Guides for all U-Line products. Combo® Models U-CO29FB-00A U-CO1224FS-00B U-CO29FW-00A U-CO1224FINT-00B U-CO1224FB-40B U-CO1224FW-00B Marine Series ULN-CO29B-03A ULN-CO29B-20A ULN-CO29W-03A ULN-CO29W-20A Visit http://www.u-line.com/product-literature/userguides or scan this QR code to view all user guides online.
QUICK START GUIDE u-line.com Safety and Warning Environmental Requirements NOTICE This model is intended for indoor/interior applications only Please read all instructions before installing, operating, or servicing the appliance.
QUICK START GUIDE Electrical ! WARNING SHOCK HAZARD — Electrical Grounding Required. Never attempt to repair or perform maintenance on the unit until the electricity has been disconnected. u-line.com Water Hookup PREPARE PLUMBING The water valve uses a standard 1/4" (6.35 mm) compression fitting. U-Line recommends using accessory water hook up kit – part # WATERHOOKUP. The kit includes a 10' (3 m) braided flexible water supply line and a brass hose fitting. When using a 1/4" (6.35 mm) O.D.
QUICK START GUIDE ! CAUTION u-line.com 3. Locate water valve inlet. Do not use any plastic water supply line. The line is under pressure at all times. Plastic may crack or rupture with age and cause damage to your home. Do not use tape or joint compound when attaching a braided flexible water supply line that includes a rubber gasket. The gasket provides an adequate seal – other materials could cause blockage of the valve. 4.
QUICK START GUIDE u-line.com Integrated models require 1/4" (6 mm) clearance if 9. Install retaining clip. installed next to a wall. Allow for additional space for any knobs or pulls installed on the integrated panel/frame. BI95/BI98 All units have a zero clearance for the door to open 90°. U-Line recommends a minimum door clearance of 1/4" (6 mm) to accommodate the handle if the unit is installed next to a wall. 1/4" Min.
QUICK START GUIDE u-line.com General Installation CRESCENT ICE MAKERS, OUTDOOR SERIES AND ADA15IM MARINE AND BI95/BI98 SERIES LEVELING INFORMATION LEVELING INFORMATION 1. Use a level to confirm the unit is NOTICE Because these units do not have leveling legs, it is extremely important that they sit on a level surface. If they are not level, the ice mold will not fill evenly. level. Level should be placed along top edge and side edge as shown. Use a level to confirm 1 the unit is level.
QUICK START GUIDE INSTALLATION 1. Plug in the power/electrical cord. u-line.com 2. Pull door gasket out of groove (top edge of door only). Start in the middle and pull outward, 2. Gently push the unit into position. Be careful not to kink the water supply line or entangle the cord. moving toward the edge. This may take some force. 3. Re-check the leveling, from front to back and side to side. Make any necessary adjustments.
QUICK START GUIDE u-line.com CO1224F Due to differences in floor construction or 1. Fully open door/drawer. surrounding cabinetry, the panel may not sit flush with the top of the door/drawer. 2. Starting at corner, pull gasket away from door/ Panel Door drawer. 3. Continue to pull gasket free from gasket channel. 9. Secure integrated panel to door/drawer 4. Upon removal, lay gasket Bar Clamp using clamps. A down on a flat surface. robust tape may also 5.
QUICK START GUIDE u-line.com 13.Be sure the screws force their way past the opening on the gasket channel and sit flush against the bottom of the channel. Integrated Panel Integrated Panel 14.Remove clamps from door/drawer. If panel requires additional adjustment after removing clamps, slightly loosen each screw and adjust panel as necessary. Tighten screws upon completion.
QUICK START GUIDE u-line.com Starting at the corners, re-install the gasket into the seated. This may take some force.Control gasket channel in the frame. Make sure the gasket is fully Operation Up Down Not Light Power Used LED CONTROL FUNCTION GUIDE FUNCTION COMMAND DISPLAY/OPTIONS ON/OFF Press and release Unit will immediately turn ON or OFF.
QUICK START GUIDE u-line.com First Use To turn off ice production: Raise the bin arm into All U-Line controls are preset at the factory. Initial startup temperature for ice storage. an upright and locked position. The unit will preserve requires no adjustments. NOTICE NOTICE If not intending to use the ice maker, turn the U-Line recommends allowing the unit to run water supply valve off. It is also important to overnight before loading with product.
QUICK START GUIDE u-line.com Warranty U-LINE CORPORATION LIMITED WARRANTY Sabbath Mode 1. U-Line Corporation (“U-Line”) warrants each U-Line product to be free from defects in materials and workmanship for a period of one year (two years on 1 2 3 4 5 6 7 Modular 3000 Series) from the date of installation.
QUICK START GUIDE u-line.com warranty does not apply to cosmetic damages. A proof 1-800-779-2547 or the dealer from whom you of purchase may be required. purchased the product. In no event shall such notification be received later than 30 days after the 4.
