Installation Guide CO2175FF — Combo® Ice Maker/Refrigerator www.U-LineService.com Phone (414) 354-0300 • FAX (414) 354-7905 Service & Parts Tech Lines Phone (800) 779-2547 • FAX (414) 354-5696 OnlineService@U-Line.
CO2175FF — Combo® Ice Maker/Refrigerator Contents Exterior Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Cut-Out Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . Product Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . Door Swing/Clearances Information . . . . . . . . . . . . . . Reversing the Door. . . . . . . . . . . . . . . . . . . . . . . . . . . . . Other Site Requirements . . . . . . . . . . . . . . . . . . . . . . . .
CO2175FF — Combo® Ice Maker/Refrigerator General Precautions 2 Inspect and Plan Use this appliance for its intended purpose only and follow these general precautions along with those listed throughout this guide: You have received a carton containing your CO2175FF Ice Maker/Refrigerator with a package inside containing a Use and Care Guide, a Product Registration Card and water connection parts. Complete and mail the Product Registration Card or register online at www.U-LineService.com.
CO2175FF — Combo® Ice Maker/Refrigerator After all the protective coating has been removed from the unit/door, clean all Stainless Steel surfaces with Claire Stainless Steel Polish and Cleaner or comparable product or a mild detergent and warm water solution and soft cloth. Do NOT use abrasive cleaning agents.
CO2175FF — Combo® Ice Maker/Refrigerator Product Dimensions Reversing the Door (Black and White Units Only) 23-11/16" Including Handle All U-Line units (except Stainless Steel models) may be left- or right-hand opening. The door opening is easily reversed by moving the hinge hardware to the opposite side. The top hinge hardware will be used on the bottom of the other side and the bottom hinge hardware will be used on the top of the other side (see Figure 4).
CO2175FF — Combo® Ice Maker/Refrigerator Other Site Requirements 4. Remove the two door closer inserts from the existing bottom hinge and install as shown on the new bottom hinge (see Figure 8). Power Supply The unit requires a grounded and polarized 115 VAC, 60 Hz, 15A circuit (normal household current). See Electrical Specifications on Page 14. 1 Water Supply Door Closer Inserts The unit requires a 1/4-inch Outside Diameter water supply line and a shut-off valve. For more information see Page 13.
CO2175FF — Combo® Ice Maker/Refrigerator Side-By-Side Installation Instructions 4 Prepare and Install Door Panel (Black and White Units Only) For a complete refreshment center, install your CO2175FF Ice Maker/Refrigerator beside a U-Line Drawer or Wine Captain Model (see Figure 11 for typical cut-out). Note that each Side-By-Side Installation will be different.
CO2175FF — Combo® Ice Maker/Refrigerator Full Overlay Door Panel Door Panel Preparation A full overlay door panel completely covers the doorframe and handle to give a built-in appearance. See your U-Line dealer for the optional Full Overlay Door Panel Kit.
CO2175FF — Combo® Ice Maker/Refrigerator Installation Instructions 15/32" Removing Existing Door ø 0.177" (#16 Drill) 11/16" Deep 1. Remove the door shelves by first pulling shelves up at a 45° angle, then straight out. TOP VIEW 3/8" 2. Remove top hinge screw pin (Phillips screwdriver). Remove the door by tilting forward and lifting off the bottom hinge pin. 31/32" .125" 3. Pull door gasket out of the groove (top edge of door only).
CO2175FF — Combo® Ice Maker/Refrigerator IMPORTANT 2-5/8" ± 1/4" Door panel and overlay panel must be aligned properly or the door will not operate correctly. Assembling the Door Drill ø 5/32" x 3/8" Deep 7 Places Model 2175 6 places Model 2115 and CLR2160 15-9/16" ± 1/4" 1. Install the assembled panel by sliding the original door panel back into the doorframe. For use with #10 x 5/8" Wood Screw and Nylon Spacer 2.
CO2175FF — Combo® Ice Maker/Refrigerator Checking Door Alignment Wood Panel Top Hinge Plate (5/8" Longer than Existing Top Hinge Plate) The unit’s door is aligned at the factory before shipment. However, its alignment could have been disturbed during shipment or during door panel installation. Pivot Post IMPORTANT Properly aligned, the door should be 1/8" below the top of the unit’s cabinet, NOT flush with the top (see Figure 28).
CO2175FF — Combo® Ice Maker/Refrigerator 5 Adjust Door Checking Door Alignment The unit’s door is aligned at the factory before shipment. However, its alignment could have been disturbed during shipment or during door panel installation. Slotted Mounting Holes Notch IMPORTANT Properly aligned, the door should be 1/8" below the top of the unit’s cabinet, NOT flush with the top (see Figure 28). Raise Outside Door Edge Lower Outside Door Edge Figure 30 1/8" 3. See Figure 30.
CO2175FF — Combo® Ice Maker/Refrigerator 2. Locate the compression fitting and ferrule packed with the unit. Slide the compression fitting and ferrule over the 1/4-inch OD water supply line. Do not use thread sealing compound or tape. Using two wrenches, tighten the compression fitting on the supply line (see Figure 33). 6 Prepare Plumbing CAUTION Plumbing installation must observe all state and local codes. All water connections MUST BE made by a licensed/ qualified plumbing contractor.
CO2175FF — Combo® Ice Maker/Refrigerator 7 Prepare Power Supply 8 Level the Unit Electrical Specifications Leveling Information CAUTION IMPORTANT It is extremely important that the unit is level. If it is not level, the ice mold will not fill evenly. Electrical installation must observe all state and local codes. This unit requires connection to a grounded (threeprong), polarized receptacle that has been placed by a qualified electrician. 1.
CO2175FF — Combo® Ice Maker/Refrigerator Door Shelves 9 Install the Unit 1. First pull shelf up at a 45° angle, then straight out (see Figure 39). Installation of the CO2175FF 1. Open the water supply valve in the main water source. Notch 2. Choose new location and line up on bosses. First push straight in, then down at a 45° angle. 2. Plug in the powercord. 3. Open the door and press the POWER icon (see Figure 40,1). to turn the unit OFF.
CO2175FF — Combo® Ice Maker/Refrigerator About Settings 10 Start-Up for the First Time No adjustments should be necessary at this time. For information about Adjusting the Temperature Control and Adjusting the Cube Size, see the Use and Care Guide. Initial Start-Up Once installation and leveling is complete, the unit is ready for initial start-up and operation. The POWER icon is located inside the unit.(see Figure 40,1).
Who to Call Service Information If the need for service arises, call the U-Line Customer Care Center directly @ 800-779-2547. To ensure accurate assistance, please have your Model Number and Serial Number and an explanation of the problem. The Model and Serial Number plate is located inside unit at upper right hand corner. If you need to locate a service company, you can go online at www.U-LineService.com and search for a service company by zip code.