ULIN_016357_30099.
ULIN_016357_30099.fm Page 2 Monday, March 27, 2006 10:22 AM 1 Introduction Congratulations on your purchase of a U-Line refrigeration product. A pioneer in the field for more than 40 years, U-Line Corporation is the world’s number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-Line dedicates 100% of its research and development to these products.
ULIN_016357_30099.fm Page 3 Monday, March 27, 2006 10:22 AM 2 Table of Contents Introduction ...............................................................................................................................2 Warranty Registration .......................................................................................................2 Please Record Your Model Information ...........................................................................2 Table of Contents ..............................
ULIN_016357_30099.
ULIN_016357_30099.fm Page 5 Monday, March 27, 2006 10:22 AM WARNING 3 Safety Precautions IMPORTANT PLEASE READ all instructions completely before attempting to install, operate, or service your unit. • Proper installation procedures must be followed if this unit is being initially installed, or is moved to a new location after being in service.
ULIN_016357_30099.fm Page 6 Monday, March 27, 2006 10:22 AM 4 Product Features 5 Operation Origins Ice Maker/Refrigerator Model CO29FF The CO29FF Ice Maker/Refrigerator with adjustable temperature control provides 2.1 cubic feet (59 L) of refrigeration in one compact unit. ULIN_0130_A • The ice maker produces up to 8 lbs (3.6 kg) of ice per day, and will store 13 lbs (5.9 kg). It conserves on water, using only 2-3/4 gallons (12.5 L) to produce approximately 22 lbs (10 kg) of ice.
ULIN_016357_30099.fm Page 7 Monday, March 27, 2006 10:22 AM Temperature Control Ice Maker Checking Product Temperature When the ice bucket is full, the ice making mechanism will shut off. However, the refrigeration system will continue to cool and maintain the cube supply. Frost-free icemaker units have lower ice production than manual defrost units. IMPORTANT Do not place cans or bottles in the ice compartment because they will freeze.
ULIN_016357_30099.fm Page 8 Monday, March 27, 2006 10:22 AM The ice bucket can be removed for emptying and cleaning. To remove the ice bucket, raise the bin arm and remove the bucket from the ice compartment. Use the ice bucket for ice storage only.
ULIN_016357_30099.fm Page 9 Monday, March 27, 2006 10:22 AM Product Disposal 6 Cleaning and Maintenance If the unit is being removed from service for disposal, check and obey all Federal, State and/or Local regulations regarding the disposal and recycling of refrigeration appliances, and follow these steps completely: General Cleaning 1. Disconnect power to the unit and unplug the power cord from its outlet. Black and White Models: 2.
ULIN_016357_30099.fm Page 10 Monday, March 27, 2006 10:22 AM Condenser Cleaning Interval - Every Three Months To maintain operational efficiency, keep the front grille free of dust and lint, and clean the condenser every three months. Depending on environmental conditions, more or less frequent cleaning may be necessary. WARNING 2 1 Disconnect electric power to the unit before cleaning the condenser. ULIN_0198_A Figure 9 WARNING 6.
ULIN_016357_30099.fm Page 11 Monday, March 27, 2006 10:22 AM Ice Cube Thickness Adjustment 4. Install the ice maker assembly cover. Interval - As Required On ice maker equipped models, the cube size may be adjusted by changing the amount of water injected into the ice maker assembly as follows: IMPORTANT Use only genuine U-Line replacement parts. U-Line ice maker parts are not the same as standard FSP Whirlpool parts.
ULIN_016357_30099.fm Page 12 Monday, March 27, 2006 10:22 AM Door Alignment Check and Adjustment 2. Remove two grille screws, and remove the grille. IMPORTANT Properly aligned, the door’s gasket should be firmly in contact with the cabinet all the way around the door (no gaps). Carefully examine the door’s gasket to assure that it is firmly in contact with the cabinet. Also make sure the door gasket is not pinched on the hinge side of the door. ULIN_0210_A Figure 16 1.
ULIN_016357_30099.fm Page 13 Monday, March 27, 2006 10:22 AM ULINE_0217_A ULIN_0144_A Figure 19 Figure 22 5. Install hinge on opposite side, bottom of cabinet (Figure 19). Replace nut on back side where installed. Align hinge outer edge with cabinet before tightening screws. 9. Remove three plastic screw plugs in hinge holes, top of cabinet, opposite side; being careful not to scratch cabinet (Figure 22). 10. Place door on lower hinge pin. Invert and install upper hinge on door.
ULIN_016357_30099.fm Page 14 Monday, March 27, 2006 10:22 AM 15. Make sure grille cap is behind grille in slots provided in grille (Figure 24, 1) before attaching grille to unit, and secure but do not overtighten both grille screws (Figure 24, 2). 16. Install the temperature control knob. 7 Service Before Calling for Service If your U-Line product appears to be malfunctioning, read through the OPERATION section of this guide to ensure that the function of all controls are clearly understood.
ULIN_016357_30099.fm Page 15 Monday, March 27, 2006 10:22 AM Troubleshooting Guide DANGER ELECTROCUTION HAZARD Never attempt to repair or perform maintenance on the unit until the main electrical power has been disconnected. Troubleshooting - What to check when problems occur: PROBLEM POSSIBLE CAUSE REMEDY Unit not cold enough Door gasket not sealing properly Adjust door (See MAINTENANCE; DOOR ALIGN, ADJUST, REVERSE). Item(s) interfering with door Reposition or remove item(s).
ULIN_016357_30099.
ULIN_016357_30099.
ULIN_016357_30099.
ULIN_016357_30099.
ULIN_016357_30099.fm Page 20 Monday, March 27, 2006 10:22 AM For General Inquiries: P.O. Box 245040 Milwaukee, Wisconsin 53224-9540 U.S.A. Phone (800) 779-2547 FAX (414) 354-5696 www.U-Line.com For Service and Parts Assistance: Phone (800) 779-2547 (414) 354-0300 FAX (414) 354-5696 Email: OnLineService@U-Line.com www.U-LineService.com E-mail: OnlineParts@u-line.
