User Manual

USER GUIDE

u-line.com

First Use

U-Line recommends allowing the unit to run

overnight before loading with product.

U-Line recommends discarding the ice produced

during the rst two or three hours of operation

to avoid possible dirt or scale that may dislodge

from the water line.

To turn the unit on or o:

Press the rocker switch located below the temperature

control dial in the center of the grille.

CONTROL DIAL

The control dial sets a single continuous temperature.

This set point temperature is a base setting used by the

controller to maintain the temperature zone in the unit.

The factory default MID setting, number 3 or 4 set point,

is approximately 38

F (3

C). The set point temperature is a

gauge for further temperature adjustments.

All U-Line controls are preset at the factory. Initial startup

requires no adjustments.

NOTICE

First Use