Installation Guide SS1095 Ice Maker www.U-LineService.com Phone (414) 354-0300 • FAX (414) 354-7905 Service & Parts Tech Lines Phone (800) 779-2547 • FAX (414) 354-5696 OnlineService@U-Line.
SS1095 Contents Follow Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . Safety Alert Definitions . . . . . . . . . . . . . . . . . . . . . . . . . General Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . Inspect and Plan . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Tools/Materials Required . . . . . . . . . . . . . . . . . . . . . . . . Inspection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Prepare Site. . . . . . . . . . . . .
MARINE SERIES SS1095 General Precautions 2 Inspect and Plan Use this appliance for its intended purpose only and follow these general precautions along with those listed throughout this guide: You have received a carton containing your SS1095 Ice Maker with a package inside containing a User Manual, a Product Registration Card and water connection parts. Complete and mail the Product Registration Card or register online at www.U-LineService.com.
MARINE SERIES SS1095 Model SS1095FC: Follow the cut-out drawing in (Figure 2). The unit must sit in a frame structure with a frame thick enough to accommodate mounting the flange to its sides and top, and a base high enough to align the door with other cabinet doors. Make the frame width 14-1/6” and the height 24-3/4”. This will allow for ease in installation and removal of the unit for servicing. 16” depth includes the water line connection.
MARINE SERIES SS1095 Model SS1095FD: Follow the cut-out drawing in (Figure 3). The unit must sit in a frame structure with a frame thick enough to accommodate mounting the flange to its sides and top, and a base high enough to align the door with other cabinet doors. Make the frame width 14-5/8” and the height 24-3/4”. This will allow for ease in installation and removal of the unit for servicing. 18-3/8” depth includes the door and water line connection.
MARINE SERIES SS1095 Product Dimensions 15-1/16” Model SS1095FC 17-9/16” including handle 17-9/16” including handle 16-7/8” including door 13-15/16” 16-7/8” including door 25-1/4” Model SS1095FD 24-3/4” Model SS1095NF 15-7/8” 13-15/16” 17-9/16” including handle 24-3/4” 16-7/8” including door 24-3/4” 26-1/8” 13-15/16” ULIN_1054_A Figure 4 Door Swing/Clearances Information Models SS1095FC & SS1095FD:Units have a zero clearance for the door to open 90° (see Figure 6).
MARINE SERIES SS1095 Reversing the Door 4. Remove bottom hinge from cabinet (two screws) (Figure 9). Depending upon the location of the unit, it may be desirable to change the side on which the door is mounted. To reverse the door mounting, perform the following: Model SS1095FC Grille screw Model SS1095FD Figure 10 ULIN_1038_A ULIN_0122_A Figure 7 5. Remove screws on opposite side of cabinet (Figure 10). 1. Remove grille (one screw) (Figure 7). 6.
MARINE SERIES SS1095 8. Using a Phillips screwdriver, remove the two screws holding the custom stainless handle from the original location, and remove the handle. Remove the two screws on the opposite side of the door (Figure 13). Do not place handle on door until you have completed, steps 9 & 10. Press in locking tab, then lightly pry up to remove hole plug and move to opposite side Figure 15 ULIN_1050_A 10.
MARINE SERIES SS1095 14. Place the door latch assembly on opposite side of unit (Figure 17). Be sure to tighten all three screws securely. 4 Service Other Site Requirements Power Supply The unit requires a grounded and polarized 115 VAC, 60 Hz, 15A circuit (normal household current). See Electrical Specifications on Page 11. Water Supply The unit requires a 1/4-inch OD water supply line and a shut-off valve. For more information see Page 10. Figure 17 Environmental Requirements 15.
MARINE SERIES SS1095 5 Adjust Door 6 Prepare Plumbing CAUTION Checking Door Alignment Plumbing installation must observe all state and local codes. All water connections MUST BE made by a licensed/ qualified plumbing contractor. Failure to follow recommendations and instructions may result in damage and/or harm. The unit’s door is aligned at the factory before shipment. However, its alignment could have been disturbed during shipment or during door panel installation.
MARINE SERIES SS1095 7 Prepare Power Supply Electrical Specifications CAUTION Electrical installation must observe all state and local codes. This unit requires connection to a grounded (threeprong), polarized receptacle that has been placed by a qualified electrician. Water Line Figure 21 Figure 22 The unit requires a grounded and polarized 115 VAC, 60 Hz, 15A power supply (normal household current). An individual, properly grounded branch circuit or circuit breaker is recommended.
MARINE SERIES SS1095 8 Level the Unit 9 Install the Unit Leveling Information Installation of the Unit 1. Open the water supply valve in the main water source. IMPORTANT 2. Plug in the power cord. It is extremely important that the unit sits on a level surface, as it does not have feet levelers. If it is not level, the ice mold will not fill evenly. 3. Gently push the unit into position. Be careful not to kink the water supply line or entangle the electrical cord.
MARINE SERIES SS1095 Installation Troubleshooting 10 Start-Up for the First Time Q: Problem Initial Start-Up Water is leaking under the unit. A: Solution The on/off switch is located behind the front grille. A small opening in the top of the grille is provided to access the switch. Ensure that the switch is turned on. A water leak under the unit is most likely caused by a bad connection in the water supply line.
SS1095 MARINE SERIES Start-Up Troubleshooting Who to Call Q: Problem Service Information Unit does not appear to turn on when plugged in. If the need for service arises, contact the dealer from whom the unit was purchased. State the Model Number and Serial Number and explain the problem. The Model and Serial Number plate is located inside unit at upper right hand corner. A: Solution Make sure outlet has power (circuit breaker has not tripped). Make sure the on/off switch is turned on.
MARINE SERIES SS1095 This page intentionally left blank. 09/2008 15 www.U-LineService.
MARINE SERIES For more than four decades, U-Line has distinguished itself as the leader in built-in undercounter ice making, refrigeration and wine storage appliances. MARINE SERIES U-Line Corporation, located in Milwaukee, WI, is a family operated manufacturer of built-in undercounter icemakers, Combo® icemaker/refrigerators, Wine Captain® wine storage units, refrigerators, refrigerated drawers and refrigerator/freezers. ©2008 U-Line Corporation Publication No. 30222E 09/2008 Rev.
