M A R I N E S E R I E S Use and Care Guide Ice Maker Model: SS1095
MARINE SERIES 1 Introduction Congratulations on your purchase of a U-Line refrigeration product. A pioneer in the field for more than 40 years, U-Line Corporation is the world’s number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-Line dedicates 100% of its research and development to these products. The result: U-Line technology consistently leads the market with innovation, design, depth of product line and performance.
MARINE SERIES 2 Table of Contents Introduction .................................................................................................. Inside Front Cover Warranty Registration .......................................................................... Inside Front Cover Please Record Your Model Information .............................................. Inside Front Cover Table of Contents ..............................................................................................................
MARINE SERIES WARNING 3 Safety Precautions IMPORTANT PLEASE READ all instructions completely before attempting to install, operate, or service your unit. • Proper installation procedures must be followed if this unit is being initially installed, or is moved to a new location after being in service. An INSTALLATION GUIDE for your unit, providing complete installation information is available from U-Line Corporation directly, and must be consulted before any installation is begun.
MARINE SERIES Origins Ice Maker Model SS1095 All Origins Ice Makers provide high daily ice production and storage capabilities, and conserve on water, using only 2-3/4 gallons (10.4 L) to produce approximately 22 lbs (10 kg) of ice. • Model SS1095 produces up to 23 lbs (10.4 kg) of ice per day and will store 12 lbs (5.4 kg). ON OFF 4 Product Features ULIN_0129_A Figure 3 Depress the ON/OFF switch (Figure 3) as required to turn the unit on or off.
MARINE SERIES Normal operating sounds may be more noticeable because of the unit’s environment. Hard surfaces such as cabinets, wood/vinyl/tiled floors and paneled walls have a tendency to reflect normal appliance operating noises. Common refrigeration components, and a brief description of the normal operating sounds they make, are listed below. NOTE: Your product may not contain all of the components listed. • Compressor: The compressor makes a hum or pulsing sound that may be heard when it operates.
MARINE SERIES Product Disposal WARNING If the unit is being removed from service for disposal, check and obey all Federal, State and/or Local regulations regarding the disposal and recycling of refrigeration appliances, and follow these steps completely: Electrical Shock Hazard. Disconnect power before servicing. Before operating, replace all panels. Failure to do so may result in death or electrical shock. 1. Disconnect power to the unit and unplug the power cord from its outlet. 1.
MARINE SERIES 3. Place a towel or other absorbent material on bottom of unit. 6 Cleaning and Maintenance Proper cleaning and maintenance of your U-Line product will ensure efficiency, top performance and long life. The maintenance intervals listed are based on normal conditions. You may want to shorten the intervals if you have pets or other special considerations. Interior Cleaning (As Required) • Turn unit off.
MARINE SERIES 1. Disconnect electrical power to the unit. Ice Maker Maintenance 2. With a standard blade screwdriver or 1/4" nut driver, remove the grille screw (Figure 8). Inlet Screen 3. Remove the grille. Interval - Every Twelve Months The solenoid valve inlet screen must be cleaned at least once each year as follows: WARNING WARNING DO NOT touch the condenser fins. The condenser fins are SHARP and can be easily damaged. Disconnect electrical power to the unit before cleaning the solenoid valve.
MARINE SERIES SS1095FD model: Align the tabs on the bottom of the grille with the slots in the flange and swing grille up into position. 3. Turn the adjusting screw toward the minus (-) sign (clockwise) for smaller cubes or toward the plus (+) sign (counterclockwise) for larger cubes. 4. Install the ice maker assembly cover. Align the grille and cabinet screw holes (Figure 8). IMPORTANT 10. Insert the grille screw (Figure 8) and tighten. Do not over-tighten. Use only genuine U-Line replacement parts.
MARINE SERIES Door Alignment Check and Adjustment 1. Remove grille (one screw) (Figure 15). 2. Remove top hinge from cabinet (three screws) (Figure 14). Hold door to keep it from falling. IMPORTANT 3. Lift the door off the bottom hinge. Properly aligned, the door’s gasket should be firmly in contact with the cabinet all the way around the door (no gaps). Carefully examine the door’s gasket to assure that it is firmly in contact with the cabinet.
MARINE SERIES 6. Install hinge on opposite side, bottom of cabinet (Figure 18). Align hinge outer edge with cabinet before tightening screws. Hinge Plastic Plug Hole Plastic Plug Hole Screw Left Side Door Swing Right Side Door Swing Invert Right Screw Side Hinge Invert Hinge ULIN_0142_A Figure 21 9. Remove plastic hole plug (Figure 22) from door handle and relocate on opposite side.
MARINE SERIES 13. Remove all three screws on the opposite side of the hinge and carefully lift off the door latch assembly (Figure 23). 7 Service Before Calling for Service If your U-Line product appears to be malfunctioning, read through the OPERATION section of this guide to ensure that the function of all controls are clearly understood.
MARINE SERIES DANGER 8 Troubleshooting Guide ELECTROCUTION HAZARD! Never attempt to repair or perform maintenance on the unit unitl the main electrical power has been disconnected. Troubleshooting - What to check when problems occur: PROBLEM POSSIBLE CAUSE REMEDY The unit frosts up. Unit is manual defrost model. Defrost unit manually (See MAINTENANCE; DEFROSTING). Door gasket not sealing properly Adjust door (See MAINTENANCE; DOOR ALIGN, ADJUST, REVERSE).
MARINE SERIES U-LINE CORPORATION LIMITED WARRANTY U-Line Corporation warrants each U-Line product to be free from defects in materials and workmanship for a period of one year from the date of purchase; and warrants the sealed system (consisting of the compressor, the condenser, the evaporator, the hot gas bypass valve, the dryer and the connecting tubing) in each U-Line product to be free from defects in materials and workmanship for a period of five years from the date of purchase.
For General Inquiries: P.O. Box 245040 Milwaukee, Wisconsin 53224-9540 U.S.A. Phone (800) 779-2547 FAX (414) 354-5696 www.U-Line.com For Service and Parts Assistance: Phone (800) 779-2547 (414) 354-0300 FAX (414) 354-5696 Email: OnLineService@U-Line.com www.U-LineService.com E-mail: OnlineParts@u-line.com For more than four decades, U-Line has distinguished itself as the leader in built-in under-counter ice making, refrigeration and wine storage appliances.
