Installation Guide

u-line.com
INSTALLATION
1. Open door/drawer completely.
2. Starting at corner, pull gasket
away from door/drawer and
remove.
3. Upon removal, lay gasket down on
a at surface.
Certain frame panels include a pre-installed black
insert. Remove the protective foil on the top and
bottom sides if applicable.
4. Align the pilot holes by placing the panel on the top
corner edge of the door/drawer.
5. Have a second person hold the panel in place or
secure with a clamp.
6. Locate the 6 #8-321-1/4
(32 mm) screws provided
with your panel. (Drawer
panels use only 4 screws
per panel)
7. Using a #2 Phillips
screwdriver, place 1 screw in
each of the 6 pilot holes and
secure. Do not over-tighten.
8. Reinstall gasket beginning at
the corners.
Accessory # Description
ULASHP15SOLID 15” (38cm) Solid Door
ULASHP15FRAME 15” (38cm) Frame Door
ULASHP18SOLID 18” (45cm) Solid Door
ULASHP18FRAME 18” (45cm) Frame Door
ULASHP24SOLID 24” (60cm) Solid Door
ULASHP24FRAME 24” (60cm) Frame Door
ULASHP24DWR 24” (60cm) Drawer
VDPU115DSS 15” (38cm) Solid Door
VDPU115GSS 15” (38cm) Frame Door
VDPU124DSS 24” (60cm) Solid Door
VDPU124GSS 24” (60cm) Frame Door
VDPUDR124SS 24” (60cm) Drawer
VDPU318DSS 18” (45cm) Solid Door
VDPU318GSS 18” (45cm) Frame Door
VDPU324DSS 24” (60cm) Solid Door
VDPU324GSS 24” (60cm) Frame Door
VDPUDR324SS 24” (60cm) Drawer
STAINLESS ACCESSORY PANEL
Align Panel
Against
Door Edge
Align top of panel with highest point of door/drawer
Wood
Panel
Door/Drawer
Bar
Clamp
Bar
Clamp
30436 Rev D 2/2019