INSTALL GUIDE ® 3000 Series: Overlay Panel, Frame and Toe-Kick Specifications WINE CAPTAIN® MODELS BEVERAGE CENTERS GLASS DOOR REFRIGERATORS REFRIGERATORS U-3018WCOL-00 U-3024BEVOL-00 U-3018RGLOL-00 U-3018RFOL-00 U-3018WCOL-01 U-3024BEVOL-01 U-3018RGLOL-01 U-3018RFOL-01 U-3024WCOL-00 U-3036BVWCOL-00 U-3024RGLOL-00 U-3024RFOL-00 U-3024WCOL-01 U-3024RGLOL-01 U-3024RFOL-01 U-3036WCWCOL-00 U-3036RRGLOL-00 U-3036RROL-00 THE MODULAR 3000 SERIES ARE INTENDED FOR BUILT IN INSTALLATIONS ONLY
1 3000 Series Overlays IMPORTANT Overlay / Frame Overlay Panel IMPORTANT • The door panel must not weigh more than 20lbs. • It is important to ensure that all drilled holes are drilled to the correct depth in order to avoid splits in the wood when hardware is installed. Appliance will need up to 34 1/2" to the under side of the counter to leave room for leveling adjustments. • Due to differences in surrounding cabinetry the panel may not perfectly align with door.
024 Series BACK SURFACE MUST HAVE AMPLE FLAT SURFACE TO MOUNT OVERLAY PANEL FLAT AND WITHOUT INTERFERENCE 3/4" MIN BACK SURFACE MUST HAVE AMPLE FLAT SURFACE TO MOUNT OVERLAY FRAME FLAT AND WITHOUT INTERFERENCE 23-1/2" 3/4" MIN 23-1/2" 2 3/4" Min 30" 30" Solid Overlay Frame Overlay Panel Installation 1. Fully open door, 2. Starting at corner, pull gasket away from door. 3. Continue to pull gasket free from gasket channel.
5. The frame should be aligned with the outside edge (opposite the hinge) and high enough to align with the highest point in the door. 10. Be sure the screws force their way past the opening on the gasket channel and sit flush against the bottom of the channel. Align Top Of Panel With Highest Point Of Door Align Frame Against Door Edge First Due to differences in floor construction or surrounding cabinetry, the frame may not sit flush with the top of the door. Door Overlay Panel 11.
1-15/32" 1-15/32" U-Line Door Panel Installation Guide 3036 Models 33-9/32" 35-7/32" 3024 Models 20-3/8" 23-9/16" 3018 Models 15-19/32" 17-17/32" 1" 1" A Dimension A may vary from a minimum of 3-1/4" to a maximum 4-1/4" depending on toe kick height. Measure toe kick height and cut overlay to same dimension.
® SERVICE INFORMATION If you have a problem with this appliance, your use and care guide has troubleshooting information to help you quickly identify common problems and provide information on possible cause and remedy. Answers to Customers Frequently Asked Questions are available at www.u-line.com/customer/faq.cfm. You may contact U-Line directly: GENERAL INQUIRIES: SERVICE ASSISTANCE: U-Line Corporation P.O. Box 245040 Milwaukee, Wisconsin 53224-9540 U.S.A.
