Quick Start Guide

QUICK START GUIDE

u-line.com

QUICK START GUIDE

u-line.com

Install top hinge and door:

1. Use alternate hinge supplied with unit and reinstall the

screws. Do not tighten..

2. Rotate door 180° to reverse and set the door onto the

bottom hinge.

3. Align flat edge of the hinge with the outer edge of the

unit.

4. Tighten three screws.

Align and adjust the door:

Align and adjust the door (see DOOR ALIGNMENT AND

ADJUSTMENT).

Install grille

Door Latch

MARINE MODELS

The door latch assembly included with your unit can be

installed to prevent the door from opening when the

vehicle is in motion.

To install, perform the following:

1. Remove the two outer most screws from the non-hinge

side.

2. Place spacer (2) over mounting holes. Place latch (1)

on top of spacer (2). NOTE: Spacer (2) only required if

included with unit.

3. Re-install the screws, but do not tighten all the way.

4. Verify door latch engagement and adjust as necessary.

5. Tighten screws.

Door latch can be used to prop door open approximately

1/2" (13 mm) when unit is not in use.