Quick Start Guide

QUICK START GUIDE
u-line.com
10
USER GUIDE
u-line.com
General Installation
Install Tower on Countertop (see template at the end of this section)

1. Use template to drill four mounting holes.
2. 
3. 
hole.
 Slide keg refrigerator into place.
5. Position gasket over mounting hole.
6. 
7. Secure tower to countertop using four Phillips screws and nuts.
Note: Screws included with the kit will accommodate many dierent countertops. For a customized t, it may be
necessary to acquire screws that are size to the thickness of your countertop.
8. 
IT IS NECESSARY to install air-tight insulation between the refrigerator and
the tower. The insulation will need to run from the interior of the refrigerator up into the interior of the tower.
Front Face
of Unit
2 ¾”
(70 mm)
Hole Diameter
Power Cord
2”
(51 mm)
24”
(610 mm)
Rear Wall
24 ⁄”
(613 mm)
12 ½”
(318 mm)
11 ⁄”
(283 mm)
1 ⁄”
(43 mm)
11 ⁄”
(300 mm)
Rear Wall
Countertop
11-1/8”
(283 mm)
Front edge of drilled hole
to front face of unit
Beverage
Tube
Insulation
Diagram A
Diagram B
Insulation
USER GUIDE
u-line.com
General Installation
Install Tower on Countertop (see template at the end of this section)

1. Use template to drill four mounting holes.
2. 
3. 
hole.
 Slide keg refrigerator into place.
5. Position gasket over mounting hole.
6. 
7. Secure tower to countertop using four Phillips screws and nuts.
Note: Screws included with the kit will accommodate many dierent countertops. For a customized t, it may be
necessary to acquire screws that are size to the thickness of your countertop.
8. 
IT IS NECESSARY to install air-tight insulation between the refrigerator and
the tower. The insulation will need to run from the interior of the refrigerator up into the interior of the tower.
Front Face
of Unit
2 ¾”
(70 mm)
Hole Diameter
Power Cord
2”
(51 mm)
24”
(610 mm)
Rear Wall
24 ⁄”
(613 mm)
12 ½”
(318 mm)
11 ⁄”
(283 mm)
1 ⁄”
(43 mm)
11 ⁄”
(300 mm)
Rear Wall
Countertop
11-1/8”
(283 mm)
Front edge of drilled hole
to front face of unit
Beverage
Tube
Insulation
Diagram A
Diagram B
Insulation