1/4"INSERT PANEL SPECS

U-Line Insert Panel Installation 1
1 Insert Panel Installation
Custom 1/4'' Thick Door/ Drawer Panel
Insert
Insert Panel Preparation
A custom insert panel may be inserted into the doorframe.
Custom insert panels can be flat or raised, as long as the maximum
panel thickness, where inserted into the door / drawer reveal
(channel), is no more than 1/4" thick. For raised panels, the depth
of the reveal is 1/4" on all four sides.
IMPORTANTIMPORTANT
Raised panels will reduce the door’s 90° swing/zero
clearance if the unit is installed next to a wall or similar
type of structure.
Panel Dimensions.
The insert panel must not weigh more than 20 lbs.
Insert Panel Installation
Door Models
1a. Remove top hinge screw pin
with Phillips head screwdriver.
Remove door by tilting
forward and lifting off bottom
hinge pin.
Model Width Height
1115R 13 15/16” 26 15/16”
1175R 22 15/16” 26 15/16”
2115R 14 1/32” 27 11/16”
2175R(F) 23 1/32” 27 11/16”
2275DWR 23 1/32” 12 15/32”
29R 19 13/16” 21 13/32”
ADA15IM 13 15/16” 26 15/16”
ADA24R 22 15/16” 26 15/16”
BI2115 14 1-32” 27 11/16”
BI95 12 15/16” 13 15/32”
BI95BTP 12 15/16” 13 15/32”
BI98 13 15/16” 15 15/16”
CLR2160 14 1/32” 27 11/16”
CLRCO2175 23 1/32” 27 11/16”
CO1175 22 15/16” 26 15/16
CO2175F 23 1/32” 27 11/16”
CO29(F) 19 13/16” 21 13/32”
Drawer Models
1b. Drawer model inserts can be
installed without removing the
drawer from the unit. Simply
pull the drawer open and follow
instructions.
2. Pull door / drawer gasket out of
groove (top edge of door /
drawer only). Start in the middle
and pull outward, moving toward
the edge . This may take some
force.
3. Remove the two outside screws
holding door / drawer handle.
Slightly separate door handle
from door.
4. Pull handle up and off.
CAUTION
Use care when handling the insert. Insert edges may be
sharp.
5. Slide custom door panel insert into 1/4-inch channel in door /
drawer front.
IMPORTANTIMPORTANT
Use care not to damage magnet, located on door bottom,
when installing door insert. Do not set door on bottom
edge when pushing insert into place.
6. Holding door / drawer gasket out of the way, replace handle on
door, making sure it is seated properly on insert and that screw
holes line up.
7. Install two small screws removed in
Step 3
.
8. Starting at the corners and working inward, push door gasket
into place on door.
Door Models Only
9. Place door on bottom hinge pin and install upper hinge screw.