Installation Guide CO1175 — Ice Maker/Refrigerator www.U-LineService.com Phone (414) 354-0300 • FAX (414) 354-7905 Service & Parts Tech Lines Phone (800) 779-2547 • FAX (414) 354-5696 OnlineService@U-Line.
CO1175 — Ice Maker/Refrigerator Contents Exterior Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Cut-Out Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . Product Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . Door Swing/Clearances Information . . . . . . . . . . . . . . Reversing the Door. . . . . . . . . . . . . . . . . . . . . . . . . . . . . Other Site Requirements . . . . . . . . . . . . . . . . . . . . . . . .
CO1175 — Ice Maker/Refrigerator General Precautions 2 Inspect and Plan Use this appliance for its intended purpose only and follow these general precautions along with those listed throughout this guide: You have received a carton containing your CO1175 Ice Maker/Refrigerator with a package inside containing a User Manual, a Product Registration Card and water connection parts. Complete and mail the Product Registration Card or register online at www.U-LineService.com.
CO1175 — Ice Maker/Refrigerator Exterior Cleaning 3 Prepare Site (As Required) Your U-Line product has been designed for either freestanding or built-in installation. When built-in, your unit does not require additional air space for top, sides or rear. However, the front grille must NOT be obstructed and clearance is required for water and electrical connections in the rear. Black Models: • Black surfaces may be cleaned with a mild detergent and warm water solution.
CO1175 — Ice Maker/Refrigerator Product Dimensions Wall Wall 25- 3/4" Including Handle 24" Including Handle 2" Min. 1/4" Min. 20-7/8" 20-7/8" 34-1/8" 34-1/8" 25-1/4" 25-1/2" 90 Door Swing 90 Door Swing 23- 15/16" BLACK CO1175 23- 15/16" STAINLESS CO1175 Stainless Black ULIN_0827_A Figure 2 Please note that the unit has adjustable feet that can add one additional inch to height during leveling or to match adjacent cabinets (see Figure 21 on Page 11). Wall or Cabinet 1/4” Min.
CO1175 — Ice Maker/Refrigerator Reversing the Door 6. Remove pivot screw from bottom hinge, invert screw and reinstall pivot screw in hinge. See Figure 6. (CO1175 Black Units Only) 7. Install bottom hinge on cabinet, opposite side, aligning flat edge of hinge with outer edge of unit. Partially tighten screws. See Figure 8. All units may be left-or right-hand opening (All Stainless Steel units cannot be field-reversed). Black Units Note: The grille should not yet be installed.
CO1175 — Ice Maker/Refrigerator Side-By-Side Installation Instructions Water Supply The unit requires a 1/4-inch OD water supply line and a shutoff valve. For more information see Page 9. For a complete refreshment center, install two of the following 1175 series units side by side: CO1175, 1175R Refrigerator or 1175WC Wine Captain®. Note that each Side-By-Side Installation will be different.
CO1175 — Ice Maker/Refrigerator 4 Prepare and Install Door Panel Units will accept a Custom 1/4" Thick Insert to harmonize with or accent the surrounding decor. If this treatment is not included in this installation, go on to 5 Adjust Door. Custom 1/4'' Thick Door Panel Insert Door Panel Preparation A custom door panel can be inserted into the doorframe. Custom door panels can be flat or raised, as long as the maximum panel thickness where inserted into the door reveal (channel) is 1/4"-thick.
CO1175 — Ice Maker/Refrigerator 5 Adjust Door 6 Prepare Plumbing CAUTION Checking Door Alignment Plumbing installation must observe all state and local codes. All water connections MUST BE made by a licensed/ qualified plumbing contractor. Failure to follow recommendations and instructions may result in damage and/or harm. The unit’s door is aligned at the factory before shipment. However, its alignment could have been disturbed during shipment or during door panel installation.
CO1175 — Ice Maker/Refrigerator 7 Prepare Power Supply Electrical Specifications CAUTION Electrical installation must observe all state and local codes. This unit requires connection to a grounded (threeprong), polarized receptacle that has been placed by a qualified electrician. Water Connection Figure 16 Figure 17 The unit requires a grounded and polarized 115 VAC, 60 Hz, 15A power supply (normal household current). An individual, properly grounded branch circuit or circuit breaker is recommended.
CO1175 — Ice Maker/Refrigerator 8 Level the Unit 9 Install the Unit Leveling Information Installation of the CO75A 1. Open the water supply valve in the main water source. IMPORTANT 2. Plug in the power cord. It is extremely important that the unit is level. If it is not level, the ice mold will not fill evenly. 3. Gently push the unit into position. Be careful not to kink the water supply line or entangle the electrical cord. 1.
CO1175 — Ice Maker/Refrigerator 10 Start-Up for the First Time Initial Start-Up The unit is shipped with the control preset to a mid-point setting between 4 and 5. Assure that setting was not altered in shipment. No other adjustments should be necessary at this time. For information about Adjusting the Temperature Control, see the User Manual.
Start-Up Troubleshooting Q: Problem Q: Problem The light doesn’t come on when the door is opened. Unit does not appear to turn on when plugged in. A: Solution A: Solution Check to make sure the light bulb is working. Make sure outlet has power (circuit breaker has not tripped). Be sure that control is not turned to the off position. Make sure the on/off switch is turned on. Q: Problem IMPORTANT See the User Manual’s Troubleshooting Guide for more solutions.