DOOR PANEL INSTALLATION GUIDE ® Overlay Door Panel Preparation and Installation Instructions The Built-In Undercounter Leader Since 1962 U-LINE.
Overlay Door Panel Door panel Preparation A Full overlay door panel completely covers the door frame and handle to give you a built-in appearance. See your U-Line dealer for the optional Full Overlay Door Panel Kit.
Installation Instructions Removing Existing Door 4 1/16” 1. Remove the door shelves by first pulling shelves at a 45° angle, then straight out. 11/16” 2. Remove the top hinge screw pin (Phillips screwdriver). Remove the door by tilting forward and lifting off the bottom hinge pin. 10 1/2” Old Handle New Handle ULIN_0403_A 12 1/2” 3. Pull door gasket out of the groove (top edge of door only). Start in the middle and pull outward, moving toward the edge. This may take some force. 4.
Door Installation Installing the Door 1. Remove the existing bottom pivot plate and replace with the Full Overlay pivot plate. 1. Remove the existing hinge from the unit, saving the door closer assembly, see below 2. Attach Overlay cap to door, opposite side of where hinges will be, see below. 2. Install the replacement top and bottom hinge onto the unit, see below. 3. Install the pivot post into the new Replacement Bottom Hinge (using phillips screwdriver) and install the hinge onto the unit.
Checking Door Alignment The unit’s door is aligned at the factory before shipment. However, it’s alignment could have been disturbed during shipment or during door panel installation. IMPORTANT Properly aligned, the door should be 1/8” below the top of the unit cabinet. NOT flush with the top. See Below. 1. Compare the top edge of the door to the top edge of the cabinet. 4. Mount the door, recheck alignment and repeat Steps 2 and 3 if further adjustment is necessary. 5.
DOOR PANEL INSTALLATION GUIDE ® SERVICE INFORMATION If you have a problem with this appliance, your use and care guide has troubleshooting information to help you quickly identify common problems and provide information on possible cause and remedy. Answers to Customers Frequently Asked Questions are available at www.u-line.com/customer/faq.cfm. You may contact ULine directly: GENERAL INQUIRIES: SERVICE ASSISTANCE: U-Line Corporation P.O. Box 245040 Milwaukee, Wisconsin 53224-9540 U.S.A.