Full Overlay Panel Specs and Installation
U-Line Door Panel Installation Guide 1
Overlay Door Panel
Door panel Preparation
A Full overlay door panel completely covers the door frame and
handle to give you a built-in appearance. See your U-Line dealer for
the optional Full Overlay Door Panel Kit.
Included In Kit:
• 1x Replacement Handle • 2x Hinge Plates
• 2x Pivot Plate • 1x Door Closer
• 1x Overlay Cap • 2x Pivot Posts
• 8x #6x2” Drywall Screw • 8x 8-32 x1/2” Screws
• 2x 8-32 x 3/8” Screws
IMPORTANTIMPORTANT
• The door panel must not weigh more than 20lbs.
• It is important to ensure that all drilled holes are drilled to the
correct depth in order to avoid splits in the wood when
hardware is installed.
• Rear view of wood panel for right-hand hinge shown. Use
mirror image for left hand hinges.
• Appliance will need up to 34 1/2” to the under side of the
counter to leave room for leveling adjustments
1. Determine cabinet toe kick height, by measuring the difference
between the surface the appliance will rest on and the bottom
of the adjacent cabinetry. Adjust panel height according to the
height of you cabinetry’s Toe Kick.
2. Cut the overlay to the dimensions in Ta b l e A & B .
3. Drill hole for upper door hinge (top of panel) using a
#16 drill bit (0.177” diameter) x 11/16” deep (See diagram
below)
4. Drill hole for lower door hinge 5/16” diameter x 1/4” deep (See
diagram below)
Ta b l e A ( W i d t h )
Table B (Height)
Note: Ta b l e B dimensions will vary based on the level of the floor.
If floor is uneven, cut panel to the next longer dimension and
adjust level legs to achieve proper fit
Full Overlay Door Panel Kit Part Number
2175 Black U-OL2175B
2175 White U-OL2175W
2115 & 2160 Black U-OL2115B
2115 & 2160 White U-OL2115W
Model Width
2175 23 3/4”
2115 & 2160 14 3/4”
C
C
D
D
23.750
15/32
3/8
13/32
3/8
13/16
1/4
SEE DETAIL
A
SEE DETAIL
B
BACK SURFACE MUST BE A FLUSH FLAT SURFACE
FOR PANEL DOORS USE A BACKER BOARD
3/16
CHAMFER 1/32" X 45°
5/16
14.750
*BI2115 & 2160 Series
*75 Series
.750
MIN
Detail B
Detail A
To e K i c k H e i g h t To e K i c k H e i g h t
3 3/4” 29 3/4” 4 1/4” 29 3/8”
3 7/8” 29 3/4” 4 3/8” 29 1/4”
4“ 29 5/8” 4 1/2” 29 1/4”
4 1/8” 29 1/2”