Installation Guide

STAINLESS ACCESSORY PANEL
u-line.com
30436 Rev C 3/2017
5. Have a second person hold the panel in place or
secure with a clamp.
INSTALLATION
1. Open door/drawer completely.
2. Starting at corner, pull gasket
away from door/drawer and
remove.
3. Upon removal, lay gasket down on a at surface.
6. Locate the 6
#8-32x1-1/4 (32 mm)
screws provided with
your panel. (Drawer
panels use only 4
screws per panel)
Certain frame panels include a pre-installed black
insert. Remove the protective foil on the top and
bottom sides if applicable.
4. Align the pilot holes by placing the panel on the
top corner edge of the door/drawer.
Align Panel
Against
Door Edge
Align top of panel with highest point of door/drawer
7. Using a # 2 Phillips
screwdriver, place 1
screw in each of the 6
pilot holes and
secure. Do not over-
tighten.
8. Reinstall gasket beginning at the corners.
Accessory # Description
U-ESP45S 18” (45cm) Solid Door
U-ESPF45S 18” (45cm) Frame Door
U-ESP60S 24” (45cm) Solid Door
U-ESPF60S 24” (60cm) Frame Door
U-DWRESP60S 24” (60cm) Drawer
VDPU115DSS 15” Solid Door
VDPU115GSS 15” Frame Door
VDPU124DSS 24” Solid Door
VDPU124GSS 24” Frame Door
VDPUDR124SS 24” Drawer
VDPU318DSS 18” (45cm) Solid Door
VDPU318GSS 18” (45cm) Frame Door
VDPU324DSS 24” (60cm) Solid Door
VDPU324GSS 24” (60cm) Frame Door
VDPUDR324SS 24” (60cm) Drawer