user guide_and_manual

USER GUIDE

Door Adjustments 1

u-line.com

SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE

Door Adjustments

CHECKING DOOR ALIGNMENT

The unit’s door is aligned at the factory before shipment.

However, its alignment could have been disturbed during

shipment.

NOTICE

Properly aligned, the door’s gasket should be

firmly in contact with the cabinet all the way

around the door (no gaps).

1. Carefully examine the door’s gasket to ensure that it is

firmly in contact with the cabinet.

2. When inspecting door alignment, make sure the door

gasket is not pinched on the hinge side of the door.

ALIGNMENT AND ADJUSTMENT

1. Loosen (do not remove) top and bottom hinge screws.

2. Align door squarely with cabinet. Make sure gasket is

firmly in contact with cabinet all the way around the

door (no gaps).

3. Tighten bottom hinge screws.

4. Tighten top hinge screws.

REVERSING THE DOOR

Location of the unit may make it desirable to mount the

door on the opposite side of the cabinet.

The hinge hardware will be removed and reinstalled on the

opposite side of the cabinet.

To reverse the door mounting, perform the following:

1. Remove grille (see GRILLE-PLINTH INSTALLATION).

2. Remove top hinge from cabinet (three screws). Hold

door to keep it from falling.

3. Lift the door off the bottom hinge.

4. Remove bottom hinge from cabinet (two screws).

5. Remove screws on opposite side of cabinet.

Hinge screws