User Manual

54
The wizard will either display the wireless network settings to guide you through manual
configuration, prompt you to enter the PIN for the device, or ask you to press the configuration
button on the device. If the device supports Wi-Fi Protected Setup and has a configuration
button, you can add it to the network by pressing the configuration button on the device and
then the on the router within 60 seconds. The status LED on the router will flash three times if
the device has been successfully added to the network.
There are several ways to add a wireless device to your network. Access to the wireless
network is controlled by a “registrar”. A registrar only allows devices onto the wireless network
if you have entered the PIN, or pressed a special Wi-Fi Protected Setup button on the device.
The router acts as a registrar for the network, although other devices may act as a registrar as
well.
Add Wireless Device Wizard
Start the wizard.