Manual

5-1: Cleaning Information
CMX-20
5 - Cleaning Information
CLEANING PATTERNS
For regular carpet cleaning use an overlapping arc pattern three times over the same
area (two passes with solution and one pass for drying). When cleaning carpets, rst
clean in circular pattern, then use the overlapping arc pattern to dry the area.
Dirtiest areas may require two or more cleaning passes. Using either pattern
shown in Figure 4-4, you should develop a comfortable rhythm. To obtain
maximum performance from your CMX-20, move it slowly and deliberately with
a 50% overlap, giving it time to clean and extract. A steady pace rather than a
frenzied one will increase efciency and production, and decrease fatigue.
The following cautions should be observed while cleaning:
DO NOT operate your CMX-20 over metal oor moldings. Damage to both the 1.
molding and the cleaning head will result.
DO NOT operate your CMX-20 on hardwood oors.2.
DO NOT operate your CMX-20 over loose or unraveled carpet seams. The 3.
cleaning head may catch and cause further damage.
DO NOT operate your CMX-20 on concrete oors. It will develop sharp edges 4.
on the extraction heads that will damage carpet bers.
DO NOT clean over the edge of a loose carpet. Instead, clean only up to the 5.
edge. Damage may occur if the extraction heads catch the loose carpet.