User Manual

24
4. Without twisting or trapping the cables, insert the Head Electronics unit into the
antenna. The Head Electronics unit should now be pushed firmly, but not forced, until
the front plate reaches the antenna housing.
Note: The cables are designed to lay across the width of the case to give smooth cable
flexing and are moulded to achieve this.
Ensure that the writing on the faceplate is the correct way up, as
the front plate is made at a slight angle and should correspond to
the angle of the front face of the antenna.
5. Tighten the two plastic headed retaining screws until finger tight. Do not over-tighten
or the protective plastic heads may be damaged.
The procedure for removing the Head Electronics unit is the exact reverse of installing.