User Manual

Setting up for field use

Connecting the antenna/Head Electronics unit combination to the

controller

Requirements:

1. Place the antenna on the floor with the handle pushed forward.

2. Select either the 2 metre long or 25 metre long, grey data cable.

3. Attach the female connector to the central circular socket on the Head Electronics unit.

This socket is marked “CONTROLLER”.

4. Attach the male data cable connector to the large circular connector on the controller

unit. This socket is marked “HEAD CONNECTOR”.

5. The radar is now ready for proximity sensor calibration and use.

Note:

Each end of the data cable is marked with the name of the unit to which it connects.

One-Man Harness Operation

The radar can be operated in “one-man” mode, whereby the operator wears the controller

attached to a body harness.

Using the harness – 500/250 MHz

Requirements:

Before following these instructions the antenna should be fully assembled, with the handle

and data cable attached.