User Manual

28
1. Remove the carry harness from the bag and remove any twists from the straps.
2. Put your arms through the arm loops. The large pads should sit on your shoulders.
The two silver rings should be positioned on either side of your waist and the large,
black, push fit waist connector at the front.
3. Fasten the push fit belt and chest connectors.
4. Make sure the two thin webbing waist straps are free and at about two-thirds extension.
5. Make sure the similar shoulder connectors are free and also at two-thirds extension.
6. Using the two adjusting buckles, lengthen or shorten the vertical straps until the
harness is comfortable.
1. Now take a belt battery pack from the carry bag and put it on, ensuring it is
comfortable and not too loose. Also, ensure the two harness waist straps are free.
2. Pick up the controller and carefully attach the two waist fasteners to the connecting
posts on the lower edges of the controller side panels.
3. Now attach the two shoulder fasteners to the remaining two connecting posts.
4. Adjust the four straps until the controller is sitting comfortably.
5. Remove the curly power cable from the bag and connect it to the controller power
socket.