User's Manual

6. Fasten the other end to the battery pack.

7. Now attach the visor to the controller.

8. Readjust the harness straps to ensure that you can comfortably view the controller

screen, without any unnecessary straining or craning of the neck.

9. Now connect the antenna to the controller by means of the grey data cable.

10. The radar is now ready for proximity sensor calibration and use.

Using the harness – 1 GHz backpack

Requirements:

Before following these instructions the 1 GHz antenna should be fully assembled, with the

Head Electronics unit installed in the belt box and a handle, if required, attached. The data

cable should be attached and the belt box fastened into the supplied black, cordura holder.

1. Remove the carry harness from the bag and remove any twists from the straps.

2. Fasten the 1 GHz belt case to the back of the harness using the four push-fit

connectors. The cables should be pointing upwards.

3. Now follow steps 2 onwards from the section entitled: Using the harness –

500/250 MHz