User's Manual

54
6 Operation of SPRscan with User Supplied Peripherals
SPRscan has been EMC tested with a representative selection of typical
commercially available peripherals such as monitors, tape backup units and
printers. Users may source peripherals from reputable manufacturers subject to
some simple precautions. To ensure that the EMC protection requirements are
met with a particular selection of user supplied peripherals, users must do the
following:
* Only use new or well-maintained CE marked equipment
* Always use shielded interface cables
* Always fully mate cable connectors and tighten locking screws
* Always operate the equipment in accordance with the manufacturers'
instructions
7 Maintenance
To ensure continued conformity with the applicable EEC directives, it is important
that repairs to sealed cases are only carried out by authorised maintenance
personnel. There are no user serviceable parts inside any of the sealed cases.
Users should inspect SPRscan and its cables on a regular basis to check for
damage to the integrity of the enclosures and cable screens and connector screen
terminations. If any damage is found, users should contact their nearest service
agent to arrange repairs and not use the equipment until these have been carried
out.
8 Upgrades
ERA continually strives to improve the performance, reliability and quality of its
products. Any system upgrades, in the form of changes to sub-assemblies or
components, must be performed by an authorised service agent.