Technical data

PD_OpManPS-4_07_us.fm
ELAU AG PacDrive PS-4 / PD-8 page 51
7.1 PacDrive PS-4
Hard-copy for correction
X8 - SERCOS
Table 7-7: Connection X8 - SERCOS connection
7.1.3 Dimensions
Fig. 7-2: Connections of the PacDrive PS-4
1
8
Pin
Designatio
n
Meaning Range
max.
cross
section
1 SEROUT+ SERCOS Out +
2 SEROUT- SERCOS Out -
3 SERIN+ SERCOS In +
4 NC not connected
5 NC not connected
6 SERIN- SERCOS In -
7 NC not connected
8 NC not connected
view from side
310
240
7
25,5
296
7
44,5
240 max. depth incl. connectors!
70
69
60
 ACHTUNG!  ATTENTION! 
 HOCHSPANNUNG! Vor Arbeiten am Gerät, Netzanschluß trennen. Entladezeit > 2min.
 ERHÖHTER ABLEITSTROM! Betrieb nur mit angeschlossenem Schutzleiter.
 HOHE TEMPERATUR! Oberfläche des Gerätes im Betriebszustand nicht berühren.
 INSTALLATION! Bei Inbetriebnahme, Installationshinweise in der Bedienungsanleitung beachten.
 HIGH VOLTAGE! Disconnect from mains supply, before working on this equipment, Electric discharge> 2min.
 HIGH LEAKAGE CURRENT!
Operation only with connected safety ground.
 HIGH TEMPERATURE! Do not touch this surface under operation conditions.
 INSTALLATION! Read installation instruction before installing.
 HAUTE TENSION! Coupez l´alimentation avant de manipuler l´appareil. Temps de décharge > 2min.
 COURANT DE FUITE ELEVEE! Fonctionnement uniquement avec conducteur de protection raccordé.
 TEMPERATURE ELEVEE! ne touchez pas la surface de l´appareil en marche.
 INSTALLATION! Respectez le manuel d´instruction lors de la mise en marche.
 ALTA TENSIONE! Disconetttere l`alimentazione prima di lavorare all`apparecchio. Tempo di scarica > 2min.
 ALTA DISPERSIONE DI CORRENTE! Operare solo con il conduttore di scarico a terra collegato.
 ALTA TEMPERATURA! Non toccare la superficie dell`apparecchio in funcione.
 INSTALLATIONE! Prima della messa in funzione dell`apparecchio consultare il manuale di istruzione
 ALTO VOLTAJE! Desconecten de la red antes de trabajar con este equipo, descarga electrica > 2min.
 ALTA TENSION! Operen solo con una conexion a tierra segura.
 ALTA TEMPERATURA! No toquen esta superficie durante la operacion.
 INSTALACION! Lean las instrucciones de montaje antes de instalar.
!
LISTED
(INDUSTRIAL
CONTROL
EQUIPMENT)
72KL
CUS
view from front
34,5 34,5
Ø6,5
PS-4
X1
24V/inac-power
X2
X3
SCL-servodrive
X4
Made in Germany
X7
X5
X6
S1
S2
diag
reset
err
pow
buserr
S3
Instructions see cover side!
!
i/o
sercos
X8
+
+
-
-
dc-bus
230 Volt !
PD_Ansicht_PS-4_2407.fh8