Installation Guide

8912VK Garage Ventilation Kit

Installation and Mounting Guide

Thank you for purchasing a Ventilation Kit from U.S. Sunlight Corp. We are committed to providing alternative energy products

that can improve your everyday life and our environment. We have reduced packaging material and eliminated Styrofoam to

reduce the impact on landlls.

If there is a problem with your U.S. Sunlight product call us at 1-877-50-USSUN

Spare parts, installation advice, or recommendations for professional installers in your area are only a phone call away.

Professional installation may be much less than you expect, please call us to get average rates for your area.

Please note that this product is designed for asphalt shingles. If you have spanish tile, s-tile, concrete, metal or at roof,

please call us before attempting to install the product.

Before beginning the installation of your Ventilation Kit, please read through the entire installation instructions and call us

if you have any questions.

This product requires the additional purchase of a U.S. Sunlight Solar Attic Fan. Call 1-877-50-USSUN to order.

Tel: 877-50-USSUN

www.ussunlight.com

support@ussunlight.com

Fig. 1

height

6”

Fig. 2

height

Step 1

Measure the distance between the underside of the roof and the top of the ceiling (g.1). Add 6” to this and cut

the exible tube to length. (g. 2)

Step 2

Rivet the two ends of the collars together to form two separate rings. (g. 3a and 3b)

Fig. 3a

Fig. 3b

PAGE 1
8912VK Garage Ventilation Kit Installation and Mounting Guide Tel: 877-50-USSUN www.ussunlight.com support@ussunlight.com Thank you for purchasing a Ventilation Kit from U.S. Sunlight Corp. We are committed to providing alternative energy products that can improve your everyday life and our environment. We have reduced packaging material and eliminated Styrofoam to reduce the impact on landfills. If there is a problem with your U.S.
PAGE 2
Step 3 Hook the end loop of wire of the flexible tube to the notches on the collar (fig.4). Duct tape the flexible tube to the two collars (fig.5). Fig.5 Fig. 4 Step 4 From underneath, insert one collar into the tunnel of the solar attic fan (fig.6a), and rivet in place (fig.6b). From the outside, seal rivet heads with silicone (fig.7). * Install the U.S. Sunlight Roof Mounted Solar Attic Fan per normal instructions. Fig. 6a Fig. 6b Fig.
PAGE 3
Insert the Ceiling Frame and attach with the included 2” Ceiling Frame Screws and plastic lugs. The plastic lugs are placed on the topside of the ceiling. Fasten the screws through the holes on the ceiling frame, the ceiling and into the white plastic lugs and tighten (fig.11a and 11b). Plastic Lug Drywall Ceiling Frame Ceiling Frame Screw Step 6 Position lower collar into ceiling frame (fig.12a) and screw in place (fig.12b).