Ultraloq UL3 Series Fingerprint and Touchscreen Smart Lock Installation Instructions Welcome ( V1.
Installation Video Please watch our easy step by step installation video before attempting to install your Ultraloq UL3 Series Fingerprint and Touchscreen Smart Lock. www.u-tec.com/support If you have questions regarding the installation process, please contact us at support@u-tec.com Important Notes • • • • • Do not use a power drill for installation. Install and test the lock with the door open to avoid being locked out. Please read all the instructions before contacting customer support.
Included in the box Exterior Assembly Interior Mounting Plate Interior Assembly Handle Spindle Screwdriver AA alkaline AA Batteries Screw A Strike Screw B Screw C Latch Screw D Backup Keys -2- Screw E Spring
STEP 1 Preparing Door Check the door’s dimensions. 13/8”~ 13/4” (35 mm-44mm) Step 1: Measure to confirm that the door is between 13/8”~ 13/4” (35 mm-44mm) thick. 2 3/4” (70 mm) OR 2 3/8”(60 mm) Step 2: Measure to confirm that the hole in the door is 2 1/8”(53 mm) . Step 3: 2 1/8” Measure to confirm that the backset is either 2 3/8”~ 2 3/4”(60mm-70mm) . 53 mm 2 1/8”(53 mm) Step 4: Measure to confirm that the hole in the door edge is 1” (25 mm) .
STEP 2 Preparing Lock If your door thickness is over 16.5”(42mm), please install this spring. Interior Spring ×1 Before installing the lock on the door 1. Slide the battery cover up and out (note the two tabs at the bottom of the battery cover). 2. Remove the inside mounting plate (with gasket) from the back (door side) of the interior assembly.
STEP 3 Installing Latch and Strike 1. Install latch on the door. Make sure the latch angle faces door jamb. 2. Install the strike on the door frame, ensuring you allow for the bolt to be centered in the strike.
STEP 4 Installing Exterior Assembly 1. Install the exterior assembly. 2. Route the cable under bolt and through hole stated below.
STEP 5 Installing Interior Mounting Plate 1. Install interior mounting plate. 2. Secure it to the exterior assembly using screws B.
STEP 6 Plug In The Spindle Plug in the spindle Spindle -8-
STEP 7 Installing Interior Assembly 1. Attach the cable to the connector on interior assembly by lining up notches on the cable connector to slots on that connector. Press the connector in firmly using thumbs until completely seated. 2. Secure interior assembly using screws.
STEP 8 Installing Batteries 1. Insert 3 AA alkaline batteries. 2. Install battery cover and tighten the screw.
STEP 9 Installing Handles 1. Press lever handles onto handle posts. 2. Test the mechanical operation of the lock by rotating handle from inside. The movement of the bolt should be smooth and unobstructed. If the operation is not smooth, review the previous steps to ensure proper installation. If the handles are installed in the wrong direction, you need to remove them and re-install. To remove the handle, you need to insert the screwdriver into the hole in the handle, push in and hold.
Keep Your Records Note: It is recommended to register several Admin fingerprints and PIN codes.
Keep Your Records Note: It is recommended to register several Admin fingerprints and PIN codes.
Note
© 2016 U-tec Group Inc. U-tec and Ultraloq brands and products are trademarked and protected under law in the United States. Unauthorized use is prohibited. Ultraloq is sub-brand of U-tec Group Inc.
