User's Manual

40
The ADSL modem card is equipped with a RJ-11 jack for
connection to the ADSL data port. The center two pins, pins 2
and 3, are used for ADSL data. For the card to make a proper
ADSL connection, the installed ADSL data port should also use
pins 2 and 3 for data. If the ADSL data port installation uses pins
1 and 4 for data, then a wiring converter will be required. Do not
alter or remove the wiring converter if present. Consult with your
ADSL provider before attempting any wiring changes.
Connector Pin-out
LED functions for the Apollo 3
Modem
LED Status Signals Description
Green LED on
t
om
PWR On 0.5s, Off 0.5
s
O
n
M
odem initialized, idle
mode (disconnect)
Power Supply OK
G
reen LED on Top SYNC On 0.25s, Off 0.25
s
(On 0.25s, Off 0.25s) x 2,
Off 0.5s
M
odem Connectin
g
Modem Connected
Yellow LED
on Top DATA On TX or RX
s
mission,
Off no data
ATM data transmission
(in showtime status)
R
ed LED on Bottom ERR On 0.25s on any CRC
r
ATM data transmission
(in showtime status)
All 4 LED
All On
D
river not installed or