Instruction manual

76
Perform aiming of the headlamps in the following sequence:
1. Place ready for road automobile with a driver's seat load
of 75 kg. on a level ground. Errect the aiming screen in front of
the automobile at a distance of 5 m. Remove the rims.
2. Switch on the headlamp and by operating the foot switch
be sure that the lower and upper beams are lighting up
simultaneously.
3. Turn on the lower beam and cover one headlamp. Adjust
the beam by turning the screws 6 (Fig. 65) until the area of the
concentrated light corresponds with the marks on the aiming
screen or the wall as indicated in Fig. 66. The adjusting screws
of the headlamp 62.3711-09 are located symmetrical about the
headlamp center in the horizontal plane.
4. Adjust the second headlamp in the same manner ensuring
that the upper edges of concentrated lights are at the same
height.
5. Fasten the rims.
Adjust the fog lamps that the area of concentrated light on the
aiming screen or the wall is located as indicated in Fig. 67. For
replacing the fog lamp bulbes, remove the cover of the bulb
holder by turning it counterclockwise and take out the bulb.
Front headlamps, rear lamps, backing lamp, side turn
indicator repeaters, rear fog lamp. For replacing the lamps, undo
screws attaching the lens and remove it.
License plate lamp. For replacing the lamp, undo the screw
attaching the cover, remove the cover and the lens.
Maintenance of the horn amounts to periodic checking it for
proper fastening, tightening the wire clamps, cleaning of dirt
and dust, and also to checking the sound intensity and adjusting,
if required.
Fig. 66. Aiming screen
for headlamp adjustment:
H - distance from
center of headlamps to
ground level