User's Manual

ϬϬʳ Important Safety Warningsʳ
“Installation” should include bonding the screen of
the coaxial cable to the earth at the building
entrance per ANSI/NFPA 70, the National Electrical
Code (NEC), in particular Section 820.93.
Grounding of Outer Conductive Shield of a Coaxial
Cable.
Ϭʳ Installation
Follow the procedures below to install the hardware.
Figure 1 illustrates the connection relationship.
1. Connect one end of the coaxial cable (not
included) to the CABLE port on the modem, and
connect the other end to the cable wall outlet. Be
sure not to bend or over tighten the cables as this
may strain the connector and cause damage. If
you plan to connect the modem and television to
the same wall outlet, you must use a cable line
splitter (not included).
2. Connect one end of the Ethernet cable to an
Ethernet port on the modem, and connect the
other end to the Ethernet port on the PC.
3. Connect one end of the Phone line cable to a
VoIP port (Tel) on the modem, and connect the
other end to the phone port of the phone set.
4. Connect one end of the DC power adapter to the
POWER port on the modem, and connect the
other end to an electric outlet on the wall.
Ϭʳ Connectors on the rear panel of
the Modem
This list of connectors describes where to connect
the cables and power adapter when installing the
cable modem.
1. POWER: This is where you connect the included
RJ11 cable. The other end connects to the phone
line port on the Telephone set.
3. ETHERNET: This is where you connect the
Ethernet RJ45 cable. The other end connects to
the Ethernet port on the PC or NIC.
4. RESET button: Reset the device to factory
defaults by pressing and holding the button for
more than 10 seconds.
5. CABLE Connector: This is where you connect
the coaxial cable (not included) that leads to the
cable splitter (not included) or the cable wall
Figure 1 illustrates the connection relationship
fails.

DS Green
Indicate sthatdataisbeing
receivedfromthecable
network.Indicatesthatthe
cablemodemhasacquireda
DSchannel.
US
Green

Indicate sthatdataisbeing
transmittedtothecable
network.Indicatesthatthe
cablemodemhasacquiredan
upstreamchannel
Ready Green
LEDwillflashslowlywhen
performingupstreamranging.
LEDwillflashquicklywhen
3
power adapter. Remember to use only the power
adapter that came with the Cable Modem.
PleaseseetheLEDdescriptionsbelow:

LED COLOR DESCRIPTION
Power Green
Indicate sthattheDevicehas
successfullycompleted
internalpower Ͳontests.LED
flashesifpowerͲonselftest
acquiringanIPAddressand
ConfigurationFile.
LEDwillremainoffifthecable
modemconfigurationfilehas
networkaccesssetto
“disable”.TheLEDwillremain
solidwhenthecablemodem
isregisteredonthecable
network.
Tel Green
LEDMUSTremainsolid,when
onͲhook
LEDMUSTflashwhenaphone
is“OffͲhook”
WPS Green
LEDflasheswhenpushingthe
HardwareWPS(attheright
outlet.
2. TEL: This is where you connect the phone line