User Manual

4
◆ LEDs on Front Panel of Device
See Figure 3 and the LED descriptions to
understand LED behavior.
Figure 3: Front Panel LEDs
LED COLOR DESCRIPTION
Power Green
Indicates the device has
successfully completed internal
power‐on tests. LED flashes if
power‐on self test fails.
DS Green
Indicates data is being received
from the cable network. Indicates
the device has acquired a DS
channel.
US Green
Indicates data is being
transmitted to the device.
Indicates the device has
acquired an upstream channel
Ready Green
LED flashes slowly when
performing upstream ranging.
LED flashes quickly when
acquiring an IP address and
configuration file.
LED remains off if the device
configuration file has network
access set to “disable.” LED
remains solid when the device is
registered on the cable network.
LED COLOR DESCRIPTION
Tel1/Tel2 Green
LED MUST remain solid when
on‐hook.
LED MUST flash when a phone
is off‐hook.
WLAN Green
LED is on when WiFi network is
available.
LAN Green
LED flashes when traffic is being
passed and indicates
connectivity between the
Ethernet port on the device and
the PC’s Ethernet port.
WPS Green
LED flashes when pushing the
hardware WPS button.
Battery Green
LED is on when the battery is
installed while Adaptor is on and
properly functioning. If there is
no adaptor, the Battery LED is
off, the Power LED blinks, and
the TEL1 LED is on. All other
LEDs are Off. If the battery is at
low power level (30mins left), the
battery LED blinks.
540. 00750. 005
540. 00750. 005
5
◆ Wall Mount Installation
This device can be mounted on a wall using the two
mounting brackets on the bottom of the device. It is
recommended to use two round or pan head screws
(not included).
1. Install two screws horizontally apart on a wall
using the measurement shown in Figure 4.
The screws should protrude from the wall in
order to fit the device between the head of the
screw and the wall. If the screws are installed
in drywall, use hollow wall anchors to ensure
that the unit does not pull away from the wall
due to prolonged strain from the cable and
power connectors.
2. Remove the device from the product package.
3. Mount the device on the wall.
Refer to Figures 4 and 5 for more details.
Figure 4: Distance (horizontal) Between Brackets
for Screws
Figure 5: Recommended Screw Size
3 ½ inches (88.0 mm)
6